User manual
Chapter 4 Display and Operation ASDA-A User Manual
4th Edition 2005/11/30, HE03 © DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
4-2
4-2 Display Flowchart
Figure 4.2 Keypad Operation
Monitor Status
Monitor
Parameter
Basic
Parameter
Extension
Parameter
Communication
Parameter
Diagnosis
Parameter
MODE
SHIFT SHIFTSHIFT SHIFT
SHIFT
to display setting value
to save setting value
SET
SET
or
or
or
(1) When the power is applied to the AC servo drive, the LCD display will show the monitor display
symbol for approximately one second, then enter into the monitor display mode.
(2) In monitor mode, pressing UP or DOWN arrow key can switch monitor parameter code. At this time,
monitor display symbol will display for approximately one second.
(3) In monitor mode, pressing Mode key can enter into parameter mode, pressing the Shift key can switch
parameter group and pressing UP or DOWN arrow key can change parameter group code.
(4) In parameter mode, system will enter into the setting mode immediately after the Set key is pressed.
The LCD display will display the corresponding setting value of this parameter simultaneously. Then,
users can use UP or DOWN arrow key to change parameter value or press Mode to exit and return
back to the parameter mode.
(5) In setting mode, users can move the cursor to left by pressing the SHIFT key and change the
parameter settings (blinking) by pressing the UP or DOWN arrow key.
(6) After the setting value change is completed, press Set key to save parameter setting or execute
command.
(7) When the parameter setting is completed, LCD display will show the end code “-END-“ and
automatically return back to monitor mode.