User manual

Chapter 7 Parameters ASDA-A User Manual
4th Edition 2005/11/30, HE03 © DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
7-48
This parameter is used to set the excessive error condition of the drive fault code (Refer to
P0-01). As for the proportion value setting of position excessive error warning condition, please
refer to P2-63)
P2 - 36 POV1
Moving Speed Setting of 1st Position Communication Addr.: 0224H
Default: 1000 Applicable Control Mode: P
Range: 1~5000
Unit: rpm
(When setting value of P2-36 to P2-43 is higher than 3000 rpm, please set setting value of P1-55
to its max. value)
P2 - 37 POV2
Moving Speed Setting of 2nd Position Communication Addr.: 0225H
Default: 1000 Applicable Control Mode: P
Range: 1~5000
Unit: rpm
P2 - 38 POV3
Moving Speed Setting of 3rd Position Communication Addr.: 0226H
Default: 1000 Applicable Control Mode: P
Range: 1~5000
Unit: rpm
P2 - 39 POV4
Moving Speed Setting of 4th Position Communication Addr.: 0227H
Default: 1000 Applicable Control Mode: P
Range: 1~5000
Unit: rpm
P2 - 40 POV5
Moving Speed Setting of 5th Position Communication Addr.: 0228H
Default: 1000 Applicable Control Mode: P
Range: 1~5000
Unit: rpm
P2 - 41 POV6
Moving Speed Setting of 6th Position Communication Addr.: 0229H
Default: 1000 Applicable Control Mode: P
Range: 1~5000
Unit: rpm