User manual

ASDA-A User Manual Chapter 7 Parameters
© DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED 4th Edition 2005/11/30, HE03
7-31
P1 - 23 PO5H
5th Position Command for Rotation Communication Addr.: 0117H
Default: 0 Applicable Control Mode: Pr
Range: +/-30000
This parameter is used to set rotation pulse number of internal position 5.
P1 - 24 PO5L
5th Position Command for Pulse Communication Addr.: 0118H
Default: 0 Applicable Control Mode: Pr
Range: +/-max. cnt/rev
This parameter is used to set rotation cycle number of internal position 5.
Stroke5 = PO5H × (cnt/rev) + PO5L
P1 - 25 PO6H
6th Position Command for Rotation Communication Addr.: 0119H
Default: 0 Applicable Control Mode: Pr
Range: +/-30000
This parameter is used to set rotation pulse number of internal position 6.
P1 - 26 PO6L
6th Position Command for Pulse Communication Addr.: 011AH
Default: 0 Applicable Control Mode: Pr
Range: +/-max. cnt/rev
This parameter is used to set rotation cycle number of internal position 6.
Stroke6 = PO6H × (cnt/rev) + PO6L
P1 - 27 PO7H
7th Position Command for Rotation Communication Addr.: 011BH
Default: 0 Applicable Control Mode: Pr
Range: +/-30000
This parameter is used to set rotation cycle number of internal position 7.
P1 - 28 PO7L
7th Position Command for Pulse Communication Addr.: 011CH
Default: 0 Applicable Control Mode: Pr
Range: +/-max. cnt/rev
This parameter is used to set rotation pulse number of internal position 7.
Stroke7 = PO7H × (cnt/rev) + PO7L
P1 - 29 PO8H
8th Position Command for Rotation Communication Addr.: 011DH
Default: 0 Applicable Control Mode: Pr
Range: +/-30000
This parameter is used to set rotation cycle number of internal position 8.