Installation guide

- 10 - - 11 -
Non-reversible heat pump
34512
RF 652
Thermostat
input
Com
230 V
Power supply
230 V
S1
S2
Do not wire
the output S1
- Menu configuration
1-06
Choice of the heat pump type
1 = Non-reversible heat pump (heat only)
LED is lit up if heat
mode is enabled
LED is lit up if “On”
is requested
RF 652
ONHEAT
- Description of the operating LEDs
The receiver is associated with the RADIO TYBOX
802 in mode 1 by default
(see radio association/ menu R section)
Fitting to the base
Position the unit on its base and lock it.
Position the thermostat
on its base.
Lock the thermostat
1 2
If necessary, the On position for the thermostat output
can be switched around. To do this:
RF 652
ONHEAT
RF 652
ONHEAT
Press the button for approximately 10 seconds
until the relay status changes
click
Mode 1 : Modification of the On position for the output S2
Mode 2 : Modification of the On positions for outputs S1
and S2
Modifying the positions of the receiver’s outputs
Mode 1