Instructions / Assembly

Service: Please do not return to store;
for immediate response email
[e-mail]
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
2
Choose desired positions for arms (Part D).
Insert into place, by hooking into slot.
3
Use scissors or utility knife to cut cosmetic cover (Part B)
to the determined height and insert into upright.
Slide or press the cosmetic pieces into the groove at the
front of the upright.
4
Assemble shelves (Part J)*
using shelf screws (Part G)*
5
Assemble upright end caps (Part C)
to uprights. (FIGURE 1)
Assemble arm end caps (Part E)
to arms. (FIGURE 2)
When aligning multiple racks vertically, use the included
connector alignment piece (Part I). First, slide the lower
half of the connector alignment piece into the lower
upright. Then slide the upper upright onto the top half of
the connector alignment piece.
Expandable Option
Once position is conrmed,
measure the distance above,
between and below each arm.
This will give you the size for
cosmetic cover. (FIGURE 1)
FIGURE 1
ABOVE
BETWEEN
BELOW
FIGURE 1
092322
FIGURE 2