Owner's manual

A 20 IOM-DPCDPR-A: FEB 2014
10.2.2. Other identification parameters, not affecting the output signal, include: device address, device type
code, factory identification code, factory device code, number of preambles (3÷20), UCS, TSD, program
version, electronics version, flags, serial number, label tag, description tag, date tag, message, record number,
sensing module number.
The process of setting the parameters listed in 10.2.1 and 10.2.2 is called “Configuration”.
10.2.3. It is possible to carry out a pressure zeroing” procedure, for example to compensate for
measurement deviation caused by a change in position during the transmitter installation.
The transmitter may also be calibrated, by taking readings with the input pressure controlled using a standard
device. This process and zero-point adjustment are called “Calibration”.
10.2.4. Configuration and Calibration of the transmitter are carried out using a Delta Controls KAP
communicator, certain Hart communicators or a PC with Hart/RS232 converter and Delta Controls D-Soft
software.
Together with the D-SOFTconfiguration software there is a „INTERVAL LINEARIZATION” software supplied
to enable the input of 21-point nonlinear functional characteristics to the transmitter.
A description of the functions of the KAP communicator is contained in the KAP Communicator Operating
Manual, and information on the Hart/RS232 converter can be found on the Hart/RS232/01 Converter
information sheet.
10.2.5. Local configuration of transmitters
10.2.5.1. Local menu - structure.
EXIT [↓][roll down] [↑][roll up] ◙ [set]
PVZERO [↓][roll down] [↑][roll up] ◙ [set]
BACK BACK
PVZERO PVZERO
SETLRV [↓][roll down] [↑][roll up] ◙ [set]
BACK BACK
SETLRV SETLRV
SETURV [↓][roll down] [↑][roll up] ◙ [set]
BACK BACK
SETURV SETURV
UNIT [↓][roll down] [↑][roll up] ◙ [set]
BACK BACK
INH2O MMH2O4
INHG INH2O4
FTH2O MPA
MMH2O MH2O4
MMHG ATM
PSI TORR
BAR KPA
MBAR PA
GSQCM KGSQCM
KGSQCM GSQCM
PA MBAR
KPA BAR
TORR PSI
ATM MMHG
MH2O4 MMH2O
MPA FTH2O
INH2O4 INHG
MMH2O4 INH2O