Instructions / Assembly

MODELS SIG110LED
Page 3.
3. Connect wiring
3-1. Follow all local electrical and safety codes.
3-2. NEVER place a switch where it can be reached from a tub or
shower.
3-3. Connect wires as shown in the wiring diagrams below.
OFF
ON
L
N
POWER SWITCH
JUNCTION BOX
SWITCH BOX
WHITE
BLACK
GREEN
GRD
OFF
ON
L
N
NIGHT-LIGHT SWITCH
WHITE
YELLOW
OFF
ON
L
N
LIGHT SWITCH
WHITE
RED
BLACK
ON/OFF SWITCH
(purchase separately)
SWITCH BOX
120 VAC
LINE IN
WHITE
GROUND
(bare)
POWER
SWITCH
WIRING
PLATE
LIGHT
SWITCH
NIGHT-
LIGHT
SWITCH
YELLOW
RED
3-4. Using wire nuts (not provided), connect the house power
cable to the ventilating fan wires.
3-5. 14 AWG (2.1 mm
2
) is the smallest conductor that shall be used
for branch-circuit wiring.
4. Grille attachment
4-1. Insert the LED light connector into the main body. (Fig. G)
4-2. With the power on, check for abnormal vibrations or sounds.
4-3. Insert the mounting springs into the slots and mount the grille
to the body. (Fig. H)
Celling
Grille
LED light
connector
Fig. G
Spring
Slots
Fig. H
5. Operation
5-1. Turn the POWER switch on/o to operate the fan / LED light /
LED night light. The LED indicator will be green when the fan is
turned on.
MAINTENANCE WARNING:
Disconnect the power source befo re working on the unit. Routine
maintenance must be done every year.
CAUTION:
1. Never use gasoline, benzene, thinner or any other such
chemicals to clean the ventilating fan.
2. Do not allow water to enter the motor.
3. Do not soak resin parts in water over 60°C (140°F).
CLEANING
1. To rem
ove the grille, pull down the spring and power
connects of the LED light engine.
2. Wash and clean the grille carefully. CAUTION: Do not let water
into the LED light engine. (Use non-abrasive kitchen
detergent and wipe dry with a clean cloth.)
3. Remove dust and dirt from the ventilating fan.
4. Using a cloth dampened with non-abrasive kitchen detergent,
remove any dirt from ventilating fan. Wipe dry with a clean
cloth.
5. Replace the grille.