Installation & Operating Manual

MODEL: ITG50LED / ITG80LED
Fig. C Fig. C
Fig. D
Fig. E
Fig. F
BLACK
ON/OFF SWITCH
(purchase separately)
SWITCH BOX
120 VAC
LINE IN
WHITE
GROUND
(bare)
POWER
SWITCH
WIRING
PLATE
LIGHT
SWITCH
RED
Fig. G
Fig. H Fig. H
Fig. H Fig. I
Fig. J Fig. K
OPERATION
1. Full speed mode: Turn the Power switch on to
operate at full speed mode.
2. LED light mode: Turn the LED Light switch to
operate ON/OFF.
MAINTENANCE:
Disconnect the power source before working on the
unit. Routine maintenance must be done every year.
CAUTION:
1. Never use gasoline, benzene, thinner or any
other such chemicals for cleaning the
ventilating fan.
2. Do not allow water to enter the motor.
3. Do not soak resin parts in water over 140 °F
(60°C).
CLEANING:
1. Pull down the spring to remove the grille.
2. Wash and clean the grille. (Use non-abrasive
kitchen detergent and wipe dry with a new
cloth.)
3. Remove dust and dirt from the ventilating fan
using a vacuum cleaner.
4. Using a cloth dampened with kitchen detergent,
remove any dirt from the ventilating fan. Wipe
dry with a new cloth.
5. Replace the grille.
SPECIFICATIONS
Note: Design and specifications are subject to change without
notice.
DIMENSIONS
WARRANTY
DELTA ELECTRONICS THREE YEAR LIMITED
WARRANTY
Delta Electronics Inc.(“Delta Electronics”)
warrants to the original consumer purchaser in the
USA that the Breez ventilation fan products will be
free from defects in material or workmanship. This
warranty is limited to three (3) years from the original
date of purchase.
Limitations and Exclusions
1. During the warranty period, a replacement for
any defective product will be supplied free of
charge for installation by the consumer. The
warranty provided herein does not cover charges
for labor or other costs incurred in the
troubleshooting, repair, removal, and installation
service.
2. All returns of defective parts or products must
include the product model number, and must be
made through an authorized Delta Electronics
distributor. Authorized returns must be shipped
prepaid. Repaired or replacement products will
be shipped by Delta Electronics F.O.B. shipping
point.
3. Delta Electronics shall not be liable for any
indirect, incidental, consequential, punitive, or
special damages arising out of or in connection
with products use or performance, regardless of
the form of action whether in contract, tort
(including negligence), strict product liability or
otherwise.
4. This warranty does not extend to fluorescent
lamp starters and tubes.
5. The warranty does not cover if user does not
comply with manufacture’s installation manual.
6. To qualify for warranty service, you must notify
Delta Electronics at the address or telephone
number below.
7. Delta Electronics shall have no liability to the
original owner-user with respect to any defect
caused by abuse, misuse, neglect, improper
transportation or storage, improper testing,
improper installation, improper operation,
improper use, improper maintenance, improper
repair, improper alteration, improper modification,
tampering or accident of products or parts
thereof, or unusual deterioration or degrada
tion of
products or parts thereof due to a physical
environment beyond the requirements of
products’ specifications.
Address: 46101 Fremont Boulevard, Fremont,
CA 94538
Toll-Free:
1-888-979-9889 - Technical Support
1-877-685-4384 - Customer Sales Support
Model No.
Voltage
(V)
Frequency
(Hz)
Air Flow
@ 0.1”SP
(CFM)
Power
@0.1”SP
(W)
Max
Current
(Amps)
Weight
(lb.)
LED
light
spec.
ITG50LED
120 60 50 5.0 0.22 4.8
13.0 W
850
Lumens
3000K
ITG80LED
120 60 80 11.3 0.28 4.8
13.0 W
850
Lumens
3000K
Joist