VENTILATION FAN MODEL 150F/150LEDNL/150LNL/150DS TABLE OF CONTENTS 150F/150DS Package Contents 2 General Safety Information 3 Preparation and Wiring Diagrams 4 Assembly Instructions 6 Grille Installation 8 Operation 9 Care and Maintenance 9 Troubleshooting 10 Dimensions 11 150LEDNL 11 Warranty 12 150LNL READ AND SAVE THESE INSTRUCTIONS Address: 46101 Fremont Boulevard, Fremont, CA 94538 US Toll Free Number: 1-888-979-9889 www.deltabreez.
PACKAGE CONTENTS PART 1 1 DESCRIPTION QTY 1 Fan Body 1 150F/150DS 2 2 1 Grille 150LEDNL 1 150LNL 3 4 3 Hanger Bar Ⅰ 13”(318.5mm) 2 4 Hanger Bar Ⅱ 13”(318.
GENERAL SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS GENERAL SAFETY INFORMATION be marked as appropriate for the application and be connected to a GFCI (Ground Fault Circuit Interrupter) – protected branch circuit. 1. Make sure that the electric service supply voltage is AC 120V, 60Hz. 8. 2. Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the Occupational Safety and Health Act (OSH Act).
PREPARATION AND WIRING DIAGRAMS Proper insulation around the fan to minimize building heat loss and gain. The ducting from this fan to the outside of the building has a strong effect on the air Roof cap Roof cap (with built-in damper) (with built-in Short piece of flexible duct helps alignment and absorbs sound straightest duct routing possible for best performance, and avoid installing the fan with smaller ducts than recommended.
PREPARATION AND WIRING DIAGRAMS CFL Light Model: 150LNL RED YELLOW SWITCH BOX JUNCTION BOX RED OFF ON WHITE YELLOW LIGHT SWITCH BLACK NIGHT-LIGHT SWITCH ON/OFF SWITCH (purchase separately) N SWITCH BOX (bare) L N OFF ON WHITE GROUND L OFF ON WHITE BLACK WHITE POWER SWITCH GREEN L WIRING PLATE NIGHT- LIGHT POWER LIGHT SWITCH SWITCH SWITCH N GRD 120 VAC LINE IN Dual Speed Model: 150DS BLUE GROUND SWITCH BOX JUNCTION BOX BLACK ON WHITE POWER SWITCH BLUE HI WHITE GREEN ON/OFF
ASSEMBLY INSTRUCTIONS Attach duct connector Note: Remove the tape from the damper before installation. C 1. Attach the duct connector from outside, and secure by using one screw (#8-32x1/4”). (Fig. C). Insert tab into hole Insert tab into the gap between fan unit and in housing housing Screw D 2. Remove the motor assembly, attach the duct connector from the housing can inside, and secure by using one screw (#8-32x1/4”). Insert and secure motor assembly. (Fig. D).
ASSEMBLY INSTRUCTIONS G 4. Ensure that the distance between the ceiling and fan body is appropriate for mounting the grille. Tab 5. Secure the suspension brackets to the joists with nails or by using the tapping screws (Ø4x25mm) through holes near nails. Joist 6. Secure the suspension bracket to the fan body using the screws (#8-32x1/4"). 7. Follow steps 2 to 6 of the installation instructions to complete the installation work. H Install the housing (II)-using mounting tabs 1.
LED light LED light connector Celling connector Celling Grille Grille Slots Spring Slots GRILLE INSTALLATION Slots LED light LED light connector Slots connector Grille Grille Slots Spring Spring K For 150F/150LEDNL/150DS 1. Insert the LED light connector into the LED socket (150LEDNL Only). (Fig. K). Spring Celling Spring Spring Slots Spring Slots 2. With the power on, check for abnormal vibrations or sounds. 3. Insert the mounting springs into the slots and mount the grille to the fan body.
OPERATION Turn the switchs on/off to operate the fan/light /night light. Dual Speed Model: 150DS Delay time control (150DS). 1. Low speed control mode: Turn the POWER switch on (MODE switch is off) to operate at the user2. Full speed control mode: Turn the POWER switch & MODE switch on to operate at full speed mode - the LED indicator will be amber.
TROUBLESHOOTING PROBLEM The fan is not turning on The fan seems louder than it should POSSIBLE CAUSE CORRECTIVE ACTION 1. Power off 1. Make sure power supply is on. 2. Faulty switch 2. Test or replace switch. 3. Faulty wire connection 3. Check wire in switch box. 1. CFM too great 1. Be sure the CFM rating on the fan matches the size of your room. 2. Damper not working properly or damaged 2. Check damper to ensure it is opening and closing properly.
DIMENSIONS 150F/150DS 14 (35 " 6) 6" (150) " 14 6) (35 7 11/16" (195) 10 1 (26 /2" 7) 150LEDNL " 3/8 11 89) (2 14" ) 6 (35 14 (35 " 6) 150LNL 14 (35 " 6) " 14 6) (35 Unit: Inches(mm) PRODUCT SPECIFICATIONS SPECIFICATIONS Model No. 150F/ VFB150E6A1 150LEDNL/ VFB150E6LED1 150LNL/ VFB150E6L1 150DS/ VFB150E6D1 Voltage (V) 120 Power Frequency @ 0.1”SP (Hz) (Watt) 60 16.9 Air Flow @ 0.1”SP (CFM) 150 Max. Weight Power (lb.) (Watt) 10.4 Light Spec Single Speed 30 13 Watt LED 120 60 17.
WARRANTY DELTA ELECTRONICS THREE YEAR LIMITED WARRANTY Delta Electronics Inc. (“Delta Electronics”) warrants to the original consumer purchaser in the USA and Canada that the Breez ventilation fan products will be free from defects in material or workmanship. This warranty is limited to three (3) years from the original date of purchase. Limitations and Exclusions 1. During the warranty period, a replacement for any defective product will be supplied free of charge for installation by the consumer.
