Installation Guide

ASSEMBLY INSTRUCTIONS (Continued)

2. Unplug fan connector from junction box.

Remove fan body from housing.

3. Insert the duct (not provided) into the duct

connector and tape all ductworks connection

to make them secure and airtight by through

the ceiling opening. Using wire nuts (not provided)

connect house wires to fan wires as shown

in the connect wiring diagram on page 8.

4. Insert housing into ceiling opening and secure

housing by using tapping screws (ø 4×25mm).

Insert fan body into housing by using three

machine screws (M4 x 45) originally on the fan

body and plug in fan connector.

1. Follow all local electrical and safety codes,

ANSI/NFPA70.

CONNECT WIRING

2. NEVER place a switch where it can be reached from a

tub or shower.

3. Using wire nuts (not provided), connect house power

cable to ventilating fan.

Connect wires are shown in wiring diagrams.

4. 14 AWG (2.1 mm ) is the smallest conductor that shall

be used for branch-circuit wiring.

TURN OFF POWER SOURCE. REVIEW ALL SAFETY PRECAUTION.

Screws