Instruction Manual

Thunderclap Kit Instructions V1 Page 10 of 11
Pictures
This is what the assembled Eurorack module looks like. Note that the ground of the output jack is wired to the ground
of the trigger jack, which is then wired to the PCB. That way, we do not need to run a wire from the output ground
hole on the PCB.
This is what an assembled stompbox looks like inside. Yours might look different depending on how you connect the
pots. Notice that we have inserted a piece of cardboard between the PCB and the side of the enclosure so that the
bottom of the PCB does not touch the metal enclosure, which would short the circuit.