Technical information

If this happens
My XM radio is not receiving a signal.
My
XM radio will not turn on.
I only receive XM channels 0 and
1.
The radio and Sound System are on and receiv-
ing a signal but I can't hear anything.
I hear noise or interference.
My remote doesn't work.
The minimum volume level is too loud or the
maximum volume is too quiet
Try this
Use the"antenna aiming"feature on the XM ra-
dio and move the antenna to another location.
Check whether the power cord is plugged into
the wall.
If applicable, make sure Auto-ON is enabled.
Make sure your radio
is activated. Contact XM
at www.xmradio.com or 1-800-XM-RADIO.
Remove the radio from the Sound System and
re·insert it. then turn the power on.
Unplug any headphones.
Check the volume control.
Make sure mute is not set on the remote if
used.
Make sure aux mode is off.
Move away from any cordless telephones or
electrical appliances or other devices that may
cause interference.
Make sure that the IR sensors are not ob·
structed.
It may be time to replace the battery in the
remote.
Adjust the line out level on your XM Radio.