Installation guide

2
Figure 2. Connect accessories to your SKYFi Home Stand as shown.
5. After powering up, if the display reads
“ANTENNA,” check that the antenna con-
nection is secure and completely pushed
in. Next, change channels (from 0 to 1 or
from 1 to 0 if the receiver is not author-
ized yet). If the “ANTENNA” message
remains, power down the radio, unplug
the antenna, and look for any obvious
damage. If no damage is detected,
reconnect the antenna, turn the unit
back on, and change channels again.
If the message still appears, contact
your retailer.
1
2
3