User guide

Getting Started

Setting Up the System

You can set up your Delphi Premium Sound System by following

these steps:

1. Connect the supplied 18-volt DC power adaptor to the jack on the rear

of the Delphi Premium Sound System. Plug the other end into the wall

outlet. You may also use 8 “C” batteries (not included).

2. The XM Antenna is located under the top cover of the Delphi Premium

Sound System. If needed (i.e. unit is placed away from a south facing

window or you live in an area without XM terrestrial repeaters), lift the

handle on the top of the unit and remove the cover to access the antenna

and wire management area.

Remove the cover by pressing

down on the two tabs with your

thumbs and sliding the cover

away from the front of the Del-

phi Premium Sound System.

Be sure that the antenna is

connected to the antenna jack

located inside the antenna

compartment on the top of

the Delphi Premium Sound

System.

You can wind the two cable

hooks in the compartment,

leaving just enough cable