SKYFi2 install guide layout 6/20/06 4:47 PM Page 2 SKYFi2™ Installation Guide H o m e a n d Ve h i c l e K i t s Contents: SKYFi2 Vehicle Adapter Kit Setup · · · · · · · · · · · · 2 SKYFi2 Installation · · · · · · · · · · · · · · · · · · · · · · · · · 7 XM Antenna Setup · · · · · · · · · · · · · · · · · · · · · · · · 12 SKYFi2 Home Adapter Kit Setup· · · · · · · · · · · · · 14 Warranty · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · 17 Warning: This manual and the SKYFi2 Satellite
SKYFi2 install guide layout 2 6/20/06 Important: See page 19 for import a n t FCC inform a t i o n .
SKYFi2 install guide layout 6/20/06 4:47 PM Page 4 Hooking up Your SKYFi2 Receiver Cradle Caution: Connect only appropriate input devices to the SKYFi2 Vehicle Adapter Kit. Connecting any incorrect input devices may damage the system and/ or the external electronic device. It is recommended that you use only the 12V to 6V conversion power adapter that came with your SKYFi2 Vehicle Adapter Kit. Figure 2. Connect accessories to your SKYFi2 Cradle as shown.
SKYFi2 install guide layout 4 6/20/06 4:47 PM After connecting the power and antenna jacks into the car cradle, the included organizer can be used to improve the appearance of the installation. See figure 3. The cable twist ties that were provided with the power adapter and car antenna cables can be reused to gather, bundle, twist tie, and secure any excess cable. Excess cable can be gathered under the dash, between the seat or console, or under the mat so it is not in the way.
SKYFi2 install guide layout 6/20/06 4:47 PM Page 6 The SKYFi2 Vehicle Adapter Kit offers you many ways of connecting your SKYFi2 to your vehicle’s radio. All options provide excellent sound quality and stereo separation. Review and consider your own unique situation when choosing from the three options.
SKYFi2 install guide layout 6 6/20/06 4:47 PM Cassette Adapter For vehicles with a built-in cassette player. Due to its superior audio quality, this configuration is recommended over the wired or wireless FM modulator configurations if a cassette slot is available in the vehicle. Page 7 Direct Connect The Delphi FM Direct Adapter (SA10112) (sold separately) can provide audio input through the vehicle’s antenna lead. (Some vehicles may re q u i re special antenna lead adapters.
SKYFi2 install guide layout 6/20/06 4:47 PM SKYFi2 Installation Because every vehicle is different, these instructions are provided as a general guideline only. If you need help, consult a professional installer. 1. Decide which method (cassette adapter, wireless FM modulator, or direct connect) is most appropriate for your vehicle and where you live. 2. Verify the system is working by completing a test.
SKYFi2 install guide layout 8 6/20/06 4:47 PM 3. Turn off the radio and SKYFi2 Receiver. Disconnect all cables. 4. Find a place where you can mount your SKYFi2 Vehicle Adapter where it is most convenient for you to use. It should be mounted to a hard, flat surface below the top of the dash within easy reach. Choosing a lower location makes it easier to manage the cables. A lower location also ensures SKYFi2 will not cause interference with other FM radios outside the vehicle. See figure 4. 5.
SKYFi2 install guide layout 6/20/06 4:47 PM b. Swivel mount: This mount allows you to adjust the angle of your SKYFi2 Vehicle Adapter after it is installed. This mount uses a strong adhesive that is not easily repositioned when installed, so use care when choosing the location of and placing the mount. Do not install this mount on a leather surface. Install the mount only if the temperature is at least 60°F. – Clean the mounting surface with the enclosed surface pre p a r a t i o n cleaning kit.
SKYFi2 install guide layout 6/20/06 4:47 PM Page 11 6. Clip the SKYFi2 vehicle cradle onto the swivel mount (figure 5). 7. Reassemble the system as in step 2. 8. Attach the antenna as explained on page 12 and route the antenna cable as described on page 13. 10 To vehicle dashboard Figure 5. Attach vehicle mount to back of SKYFi2 as shown.
SKYFi2 install guide layout 6/20/06 4:47 PM Removing swivel mount from your dashboard You can remove the swivel mount from your dashboard by following these steps: 1. Lift one edge of the adhesive pad gently with fingers or the rounded edge of a spoon. Once enough of the edge is loosened to grip with your fingers, pull the pad gently from the mounting surface at a 90-degree angle. Do not use sharp tools that could damage the vehicle’s interior. Page 12 2.
SKYFi2 install guide layout 12 6/20/06 4:47 PM XM Antenna Setup For best reception, the XM Antenna should be placed either: – In front of the rear window (option1) – Behind the windshield (option 2) When deciding which location to choose, keep in mind: – The antenna will perform best if it has an unobstructed view of the open sky and is surrounded by a minimum of 3 to 6 inches of metal. – For best FM modulator perf o rmance, locate the antenna as close to the vehicle’s FM antenna as possible.
SKYFi2 install guide layout 6/20/06 4:47 PM Page 14 Routing the Cable Option 2 When using option 2, route the cable along the door jamb and into the vehicle as shown in figure 6. Route the cable across the weather seal near the bottom of the door to reduce water leaks. Option 1 When using option 1, route the cable into the trunk as shown in figure 6. Always cross the weather seal at the lowest part of the trunk to reduce water leaks.
SKYFi2 install guide layout 14 6/20/06 4:47 PM Page 15 SKYFi2 Home Adapter Kit (SA10103) Setup Your Delphi XM SKYFi2 Home Adapter Kit contains the following components: Hooking up Your SKYFi2 Receiver Home Stand Note: See SKYFi2 User Guide for important user information. SKYFi2 Home Stand 6V AC power adapter XM High-gain Indoor/Outdoor Home Antenna with 25 ft. cable Audio cable Figure 7. SKYFi2 Home Adapter Kit components.
SKYFi2 install guide layout 6/20/06 4:47 PM Page 16 Installation instructions: 1. Turn off both your SKYFi2 Receiver and home stereo. 2. Connect cables as illustrated in figure 8. 3. Position the XM Antenna so that it is facing south. Ideally, it should point through a window. 4. Turn on your SKYFi2 Receiver and the stereo. Tune to XM channel 1. You should be able to hear the XM Preview channel. If not, check all connections.
SKYFi2 install guide layout 16 6/20/06 4:47 PM Aiming the XM Home Antenna For best reception, aim the home antenna by following these instructions: 1. Press the “menu” button on the SKYFi2 Receiver. 2. Use the scroll wheel to select the “Antenna Aiming” option. Press the “XM” button to confirm selection. 3. This display will remain on until you press the “menu” button again, so you have plenty of time to aim the antenna. Slowly turn and tilt the antenna.
SKYFi2 install guide layout 6/20/06 4:47 PM Delphi Limited Consumer Warranty Delphi Product and Service Solutions (“Delphi”) warrants all Portable XM Satellite Radio Accessory Products sold by Delphi (each “Product”) to be free of defects in material and workmanship, subject to the following conditions: The duration of Delphi’s warranty with respect to each product is limited to one (1) year from the date of sale to the original consumer purchaser.
SKYFi2 install guide layout 18 6/20/06 4:47 PM How you (the Customer) can get service: To obtain warranty service, you must return the defective Product with the original receipt to the original place of purchase. If f u rther clarification or additional information is required from Delphi, you may call Delphi at: 1.877.GO DELPHI (1.877.463.3574).
SKYFi2 install guide layout 6/20/06 4:47 PM FCC Statement Please note that the cables and antenna wire that have been supplied with your device are supplied with permanently attached ferr i t e beads. It is the responsibility of the user to use the cable and antenna wire with the ferrite beads. The user is cautioned that changes or modifications not expressly approved by XM Satellite Radio, Inc. can void the user’s authority to operate this device. This device complies with Part 15 of the FCC rules.
SKYFi2 install guide layout 6/20/06 4:47 PM Page 1 Delphi Corporation 1441 West Long Lake Road Troy, Michigan 48098-5090 U.S.A. Customer Service: [1] 877.GO DELPHI www.delphi.com Printed on Recycled Paper ©2006 Delphi Corporation. All rights reserved. DPSS-06-E-061 The SKYFi2 name, XM name, and related logos are trademarks of XM Satellite Radio Inc. All other trademarks are the property of their respective owners.
