Owner`s manual

Operation Manual Delphi NAV200
5
Section 1 NAV200 Introduction
For best results when using Delphi NAV200:
• When the Delphi NAV200 is connected to power for the first time, leave it
connected for about two hours to charge the battery.
• Plan your route before your journey. If you need to set up a new itinerary en
route, safely park your vehicle before making changes.
• GPS signals cannot pass through solid materials other than glass. So when
you are inside a building or tunnel, GPS may not be available. Likewise,
signal reception can be affected by overhead cover such as trees. Wireless
devices may also interfere with signals, causing variable reception.
• While the Delphi NAV200 can be operated by finger touch, more precise
control can be achieved by using the stylus. Do not use other sharp objects,
which can damage the LCD screen.
• Never clean the Delphi NAV200 with the power on. Use a soft, lint-free
cloth moistened with water to wipe the screen and the exterior. Do not use
paper towels to clean the screen. Do not place anything on top of the Delphi
NAV200. Do not drop the Delphi NAV200 or subject it to severe shock.
• Keep the Delphi NAV200 away from excessive moisture and extreme
temperatures. Do not subject the Delphi NAV200 to sudden and severe
temperature changes that could cause condensation inside. In the event of
moisture condensation, allow the Delphi NAV200 to dry out completely
before use.
• Always disconnect the receiver from the power supply when leaving the car
parked for a long period or when not using the system during travel. Failure
to do so could drain the vehicle’s battery as the Delphi NAV200
continuously draws power, even when the power is off.
Warning: Never attempt to disassemble, repair, or make any modification to
the Delphi NAV200. Doing so could result in personal injury, death, and/or
damage to the Delphi NAV200 and/or to your vehicle.