Owner`s manual

Delphi NAV200
12
To remove the suction cup, pull the lever up. Pull the release tab to release the
suction.
If the suction cup does not adhere, clean the mounting area of the windshield with a
cloth dampened with isopropyl alcohol. Let the area dry, and then reapply the suction
cup.
Car Mount Precautions
 The heating and cooling cycle of a vehicle’s interior will in some cases loosen
the adhesion of the suction cup.
 Check the vacuum seal of the car mount for adequate adhesion each time you
use the unit and reinstall it if necessary.
 If the car mount has problems staying on, clean the plastic suction cup with
alcohol, then reinstall. Moistening the suction cup may help adhesion in some
cases.
 To avoid extreme temperature from damaging the car mount, remove the unit if
the temperature inside your vehicle exceeds 70 °C.
 The dip in humidity and temperature at night may loosen the adhesion of the
suction cup. For this reason, as well as for security, it is recommended that you
remove both the car mount kit and the Delphi NAV200 when leaving your
vehicle overnight.