Owner`s manual

Operation Manual Delphi NAV200

Section 3 Installing Delphi NAV200 in Your Vehicle

Warning: To avoid personal injury, follow the safety guidelines and installation

instructions provided so that the Delphi NAV200 does not obstruct the view of the

driver, interfere with the operation of any airbags and safety features in the vehicle,

or become airborne in the case of an accident. Do not attempt to install Delphi

NAV200 while driving.

Before installing the Delphi NAV200, check whether your vehicle is fitted with a

heat-reflecting or heated windshield. If so, you will need to purchase an external

antenna from your retailer to allow your unit to pick up the GPS signals.

Note: Alternative-mounting options may be available for your vehicle make and

model. Contact your retailer or Delphi for more information.

Note: Some countries prohibit the mounting of any electronic device in any location

on the vehicle dashboard. Be sure to check the local laws for applicable mounting

before installing the car mount.

Note: In the state of California and Minnesota, it is necessary to use the dashboard

mount, according to state law.

To mount the suction mount to the windshield, follow these steps:

Flip up the GPS Antenna

Using the two tabs on the bottom of the

cradle, locate the Delphi NAV200 and

rotate rearward. While pushing in the two

grey release buttons, continue rotation

until unit is firmly seated in the cradle

Release the two grey buttons. Reverse

operation for unit removal.

Position suction cup firmly against

windshield at desired location.

Flip the lever towards suction cup. Unit is

now secure for operation.