User's Manual

Owner´s Manual DEA601 Radio
62 | P a g e
Tips and Troubleshooting
Radio
Unable to tune stations
You are in a weak signal area.
 Increase the Seek Sensitivity (see Seek Sensitivity section for
details).
Power operation
The system operates at 14Vdc nominal voltage, minimum of 10.5Vdc and a
maximum of 16Vdc. The maximum temperature of the system at nominal
conditions is 47°C.
If the battery is disconnected before or at the same time as the ignition line,
the system does not guarantee the memory retention.
The time of day is be set to the default value when the battery is
disconnected.
Installation
It is recommended that the system has an external current protection with a
maximum 8A fuse once is installed in the vehicle.
CD
CD player not functioning
Out of the operation range, Operation temperature of the CD is -20°C to
55°C (-4°F to 131°F).
 Allow the vehicle´s interior temperature to increase or decrease
(depending on the case).
CD Insertion is not possible
A CD is already on the CD player.
 Eject the CD and remove it.
iPod
iPod does not play or there is no sound
The iPod has not been recognized.
 Verify that the iPod is supported.
 If the iPod is supported, reset the iPod and re-connect again (see
iPod section for details).
iPod not functioning
Out of the operation range, Operation temperature of the iPod player is -
20°C to 85°C (-4°F to 185°F).
Allow the vehicle´s interior temperature to be in human supportable range.
Bluetooth
My radio doesn't recognize my Bluetooth enabled device.
Try one of the following actions:
1. Remove the device, after that pair and connect the device. Refer to
DELETE ONE OR DELETE ALL DEVICES and to Pairing a Bluetooth
Device and Connecting a Device sections.
2. Make sure the device is turned on.
3. Make sure the Bluetooth adapter on your radio is enabled, Refer to
Bluetooth Enabling/Disabling section.
4. The device might be out of range. Try moving it closer.
The device and my radio can't communicate.
Try one of the following actions:
1. Make sure that you selected the correct device to be connected to. For
example, you might have two or more devices previously paired or
connected, so make sure you selected the right device.
2. Some devices require a passkey before they can be connected to the
radio.
3. Probably an incorrect passkey was typed or the time limit expired for
typing the passkey. Refer to Connecting a Device section.