User's Manual

World Headquarters and Customer Center 5725 Delphi Drive Troy, Michigan 48098-2815 USA
October 21, 2011
Re: Certification for Delphi RSDS
Model / FCC ID: L2C0049TR
IC: 3432A-0049TR
The device under test is manufactured by the grantee
(Delphi Electronics & Safety) and sold as an OEM
product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-user has
all applicable / appropriate operating instructions. When end-user instructions are required, as is the case
with this product, the grantee must notify the OEM to notify the end-user.
Delphi Electronics & Safety will supply the following information to the reseller/distributor dictating what
must be included in the end user’s manual for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL
The following information (in blue) must be included in the end product user’s manual to ensure
continued FCC and Industry Canada regulatory compliance. The ID numbers must be included in the
manual if the device label is not readily accessible to the end user. The compliance paragraphs (in
blue) below must be included in the user's manual.
************************************************************************
Model / FCC ID: L2C0049TR IC: 3432A-0049TR
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Note: Changes or modifications not expressively approved by the party responsible for compliance could
void the user's authority to operate the equipment. The term “IC:” before the radio certification number only
signifies that Industry Canada technical specifications were met.
Note: This equipment complies with radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance of 20 cm between the radiator and
the body of any persons, user or bystander.