User's Manual

Adaptive Cruise Control
3
The steering wheel switches operate as follows:
(
B
)
‘SET +’:
Set speed or accelerate
(
C
)
‘–’:
Decelerate
(
D
) Gap decrease
(
E
)
‘RESUME’:
Resume set speed
(
F
) Gap increase
(
G
)
‘CANCEL’:
Cancels without erasing memorised speed
Setting a speed
Push the ON/OFF switch (
A
) and allow it to come to the raised
position. A red warning light on the switch will come on
indicating that the system is available for use, unless there is a
fault with the system.
Accelerate as normal until the required speed is reached.
Press the ‘SET +’ button (
B
) briefly and the vehicle speed will
then be stored in the memory and the system engaged. The set
speed will be displayed on the message centre.
Entering the follow mode
!
WARNING:
When in follow mode the vehicle will not decelerate
automatically to a stop, nor will the vehicle always
decelerate quickly enough to avoid a collision without
driver intervention.
Once a set speed has been selected, the driver can release the
accelerator and the set road speed will be maintained.
When a vehicle ahead enters the same lane or a slower vehicle
is ahead in the same lane, the vehicle speed will be adjusted
automatically until the time gap to the vehicle ahead
corresponds to the gap allowed by the system. The vehicle is
now in ‘follow mode’.
The tell tale in the instrument cluster will be illuminated
and the message centre will display the gap for four seconds.
JWK-170
SETSPEED
ìêíýNPîK
GAP