User`s manual

Delphi Display Systems, Inc. RDC-SFWESQWK100 Page 3 of 6

Confidential Document:

Do not copy or distribute without written permission from Delphi Display Systems, Inc.

1 Introduction

This guide is intended as a supplement to the OCS Configuration Tool User’s Manual. It provides an overview of certain

common tasks which may be performed using the OCS Configuration Tool. For more detailed information, refer to the OCS

Configuration Tool User’s Manual.

Figure 1 – Generic Layout of Properly Wired System

The Figure above shows what a properly wired system should look like. It details where you would plug in a serial

cable if you are using a back office computer to run the Delphi Configuration Tool as well as detailing what is

needed if you are dialing into the system using a remote computer at a different location. The Delphi Intelligent

Modem Switch (IMS9000) is typically installed on a wall inside the office at each store.

Please contact Delphi Technical Support if you have any questions or need any assistance at any point while

following the instructions contained within this document at 1-800-456-0060.