Instruction Manual

12
Safety device/Maintenance/ Troubleshooting
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance doesn't work - Be sure it is plugged in and that the
electrical outlet is working.
- Check for any obstruction.
- The temperature may be set too low.
- Plug into the power outlet.
- Remove the obstruction and let the
appliance cool down. If the appliance
doesn't work please contact the
De'Longhi Customer Service .
- Set the temperature to a higher position.
en
Delayed stop: with the appliance on, press the timer button
. The symbol is displayed ashing together with the
hours left before the appliance goes on-standby.
Change the hours using the + and - buttons, then wait a few
seconds for the program to be stored. The current settings
and symbol are displayed. At the end of the set time the
appliance switches on-standby automatically. To go back to
operating without the timer, press the timer button twice.
The timer symbol disappears from the display.
Note: the time is settable from 0.5 to 24 hours.
Change of the temperature scale
The display can show the temperature in both °F and °C.
To select the desired temperature scale, when the unit is in
standby position, press and hold the "+" and "ECO" keys for
at least 10 seconds, then release. The change of scale will be
indicated by two short beeps.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
(Probe Failure)
With this alarm the appliance does not
operate. Contact the De'Longhi Customer
Service.
(High temperature)
When the product’s internal temperature
is too high, the heating power will
progressively and automatically be
reduced. The display shows for two
seconds, cycling. To remove the cause
of this alarm check that the unit is not
covered or obstructed.
SAFETY DEVICE
A safety device switches the heater o in the event of
overheating. To restart the heater, call the De'Longhi
Customer Service.
MAINTENANCE
Always remove the plug from the power outlet and allow the
radiator to cool. Wipe radiator with a soft damp cloth, do not
use detergents and abrasives. Should the radiator not be in
use over a certain length of time, wind the cord around the
cord holder and store it in a dry place. This appliance has been
built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater
by yourself: this may result in a re hazard or electric shock.
Call the De'Longhi Customer Service (see attached list of
De'Longhi Customer Service).
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power “