Instruction Manual
9
- The rst time you use the appliance, operate it of at
least 15 minutes with the thermostat at maximum to
eliminate the “new” smell. A little smoke due to the
protective substances applied to the heating element
before transport may be given o.
- Do not obstruct the hot air outlet grilles or the air intake
grille on the bottom of the appliance.
- Position the appliance so that the plug and the outlet
can be easily reached even after installation.
- Do not use the appliance in rooms less than 4 m
2
in area.
- The appliance is tted with a safety device which will
switch o it in case of accidental overheating.
To reset, please contact Customer Experience, see
enclosed guarantee.
Disposing of the appliance
The appliance must not be disposed of with hou-
sehold waste, but taken to an authorised waste se-
paration and recycling centre.
DESCRIPTION
A display
B on-standby button
C power button
D decrease button
E increase button
F timer button
G brightness button
H eco button
I cord holder
L wheel
USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in
order to prevent damaging the paint nish.
Fully unfold the wheels by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface area
of less than 43 square feet (4 sq.m.).
Power connection
- Before using the appliance check that your supply
voltage is the same of that shown on the rating label
of the unit and that the power socket and power supply
line correspond to the load specied.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
The appliance will be set in the stand-by condition.
The display will show the symbol. Keep loose clothing
or bedding, furniture and ammable material away from
the power outlet where the heater is plugged in. After an
interruption of the power supply (power failure or appliance
unplugged) the unit goes always to stand-by. When the
unit is switched on by pressing the on-standby button, the
operating conditions will be same ones previously set.
Heating function
To turn the appliance on, press the (B) button.
Press button (C) to set the required power level:
MIN ( ); MED ( ); MAX ( ). To select the
desired temperature, press button + or - (E or D). By pushing
the + or - button once, the temperature (shown on the
display) will increase or decrease by 1°C. Keeping the + or
- button depressed the value will increase o decrease rapidly.
The appliance allows to set the temperature from 5° to 28°C.
Anti-freeze function
Setting the temperature to 5°C with the "-" button, the
appliance will activate the Antifreeze function. The display
will show the symbol, in this way the appliance will
turn on automatically, at the max power, only if the room
temperature falls below 5°C, to prevent freezing conditions.
If you wish to go back to the Heating function, press the "+"
button once.
Eco function
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
To activate this function press the "ECO" (H) button. The
display will show symbol. If the selected temperature
is much higher then the actual room temperature, the
appliance will start automatically and rapidly to heat the
room.
The appliance will automatically select the most convenient
power level (MAX-MED-MIN-OFF).
If MAX power level has been selected using the
button, the appliance will cycle between: MAX-MED-MIN-
OFF.