Instruction Manual

Using the remote control unit (some models only)

and the receiver).

• Theremotecontrolmustbehandledwithextremecare.

Do not drop it or expose it to direct sunlight or sources of

heat.

• Replacethecover.

DESCRIPTION OF THE REMOTE CONTROL

19) “ON/OFF” button

20) Increase /Decrease button for temperature/programmed

use

21) “MODE” button

22) “TIMER” button

23) °F/°C scale button

24) Fan speed selection button (MAX/MED/MIN).

Inserting or replacing the batteries

• Removethecoverontherearoftheremotecontrol;

• Removetheoldbatteries,ifpresent.

• CorrectlyinserttwonewL03“AAA”1,5Vbatteries(seethe

instructions inside the battery compartment);

• Replacethecover.

If the remote control unit is replaced or discarded,

the batteries must be removed and disposed of

in accordance with current legislation as they

are harmful to the environment. Do not mix old

and new batteries. Do not mix alkaline, standard

(carbon-zinc) or rechargeable (nickel-cadmium)

batteries. Do not dispose of batteries in re.

Batteries may explode or leak. If the remote

control will not be used for a certain length of

time, remove the batteries.

TURNING THE APPLIANCE ON

Plug the appliance into the mains.

Press the ON/OFF button (19) (when turned on, the air

conditioner starts operating in the same mode as when it was

turned o).

Press the MODE button (21) to select the required mode

COOLING

DEHUMIDIFYING

FAN ONLY

On the control panel, the light corresponding to the selected

mode comes on.

For air conditioning/dehumidifying/fan only settings and

programming the timer, see page 8.