Specifications

- 6 -
Abstergent
Gasoline
Thinner
Operation
Draining the water
The drainage tank is full
When the drainage tank becomes full (approx, 6 Litres), the full indicator lights to alert the user, and the
unit turns off automatically. Empty the water from the tank and discard it.
Drainage steps Notation for drainage
1. Remove the drainage tank
Lightly pressing on the sides of the tank with
both hands, pull it gently out.
Do not remove the bubble packing from the float
on the unit. The float on the unit will no longer be
able to detect without the bubble packing when the
water level is full, and water may leak from the
tank.
If the drainage tank is dirty, wash it with cold or
lukewarm water. Do not use detergent, scouring
pads, chemically treated cloths, or other cleaning
solutions as it may damage the drainage tank.
When replacing the drainage tank, press the tank
firmly into place with both hands. If the tank is not
positioned properly, the “ Tank Full” sensor will
activate, and the dehumidifier will not operate.
Check to make sure the guards are firmly attached
to the tank. If they are not, the drainage tank will
be harder to remove.
If the drainage tank is removed while the unit is in
operation, or immediately after operation has
stopped, water which is still in the cooling unit may
drip out on the base plate. Wait at least 30 minutes
before removing the drainage tank.(If water has
dripped, wipe it up.)
Take hold of the handle, and then remove the tank.
2. Discard the water
3. Place the drainage tank back in it’s
compartment.
Drain water
from this point
Guard