Specifications

- 5 -
Operation
1.Plug the power supply plug into the outlet
Turn the control switch to “ ”
Dehumidifying stops.
Never stop the unit by unplugging the power supply cord.
Be sure after 3~ 5 minutes to restart the unit again when the unit
is stopped or power supply is cut.
2.Open the louver by hand
3.Switch the operation mode
4.Stop operation
Use single phase 220V ~ 240V AC power supply.
Wipe dust off of the power supply plug and insert the plug firmly,
all the way to the rubber section, if there is a dust on the plug, or
the plug is not fully inserted in the outlet, electrical shock and/or
fire may result.
Never scratch, cut, or damage the power supply cord.
Power indicator lamp lights to indicate that power is on.
Before operation please check and make sure the louver has been
opened to ensure adequate air flow.
Set louvre to desired angle (when room temperature is above
DEHUMIDIFY mode: Turn the control switch to “ ” . Operation
is continu
ous ,with the amount of discharged air at the middle level.
LAUNDRY mode: Turn the control switch to “ ” . Operation is
continu
ous,with the amount of discharged air at the high level.This
is appropriate for enhanced dehumidifying,drying clothes or other
items.
QUIET mode: Turn the control switch to “ ”. Operation is
continu
ous,with the amount of discharged air at the low level.This
suppresses operation noise when dehumidifying ( Under the
condition of high temperature and high humidity,please avoid
operating the unit in QUIET mode,as this can decrease the life of
the unit.)
230-240V AC
set louvre to vertical position to allow maximum air flow.)
32