Instruction Manual

9
(see Fig. 4).
- Hang the radiator on the support.
- Mark out the 2 lower xing points (g. 2).
Remove the appliance, drill the lower holes and insert
the wall anchors.
- Now, you can hang back the heater on the support and
x the lower part of the appliance with the 2 remaining
screws (I).
USE
Functioning and use
- Insert the plug into the mains.
- Turn the thermostat knob in a clockwise direction until it
reaches the 6 setting.
- Minimum power: turn the function knob to setting
“MIN” (the pilot light will light on).
- Maximum power: turn the function knob to setting
“MAX” (the pilot light will light on).
- Switching o: turn the function knob to setting “0”
and remove the plug.
Adjusting the thermostat
Turn the thermostat knob in a clockwise direction until
it reaches the maximum setting (6). When the room has
reached the desired temperature, slowly turn the thermostat
knob counter-clockwise until you hear a click and not
beyond. The thermostat will now adjust the set temperature
automatically keeping it constant.
Frost prevention mode
With the thermostat dial at minimum and the
mode selector on "MAX", the appliance maintains room
temperature at about 5°C, preventing freezing with minimal
energy consumption.
MAINTENANCE
Before carrying out any maintenance, unplug the heater from
the mains and wait for it to cool o completely. This heater
requires no particular maintenance. It is sucient to remove
the dustwith a soft, dry cloth. Never use abrasive powders or
solvents. If necessary remove concentrated areas of dirt with
a vacuum cleaner.
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power HMP1000: MIN 500W-MAX 1000W
HMP1500: MIN 750W-MAX 1500W
HMP2000: MIN 1000W-MAX 2000W
PROBLEM CAUSE SOLUTION
The appliance doesn’t work Be sure it is plugged in and that the electri-
cal outlet is working.
Check for any obstruction.
The power selector is in the ”0” position.
The thermostat may be set too low.
Plug into the outlet.
Remove the obstruction, unplug the heater
and let the appliance cool down. If the appli-
ance doesn’t work please contact the nearest
service center.
Turn the power selector to the position MIN,
MAX.
Turn the thermostat clockwise to a higher
setting until the appliance restarts.
TROUBLESHOOTING