Instruction Manual
8
before transport may be given o.
- Do not obstruct the hot air outlet grilles or the air intake
grille on the bottom of the appliance.
- Position the appliance so that the plug and the outlet
can be easily reached even after installation.
- Do not use the appliance in rooms less than 4 m
2
in area.
- The appliance is tted with a tilt-switch which turns
the appliance o if it should fall over.To restart the
appliance, simply place it upright again.
- The appliance is tted with a safety device which
will switch the appliance o in case of accidental
overheating. To reset, disconnect the plug from the
power socket for a few minutes, remove the cause of
overheating then plug the appliance in again. If the
appliance doesn't work please contact the De'Longhi
Customer Service.
Disposing of the appliance
The appliance must not be disposed of with
household waste, but taken to an authorised waste
separation and recycling centre.
INTRODUCTION
Thank you for choosing a De’Longhi product.
Please take a few moments to read the instructions to avoid
risks or damage to the appliance.
DESCRIPTION (electric portable local space
heater)
a Power selector
b Pilot lamp
c Thermostat
d Wheel
FIRST USE
General instructions
Remove the heater from the packaging.
Check that neither the heater nor the power cable has been
damaged during transport.
Do not operate the heater if damaged.
Remove all publicity material present on the appliance.
Your heater is suitable for either freestanding or wall
mounting usage.
Do not assemble the feet if wall mounting.
Electrical connection
- Before plugging in the appliance, check that your supply
voltage is the same as that shown on the rating plate of
the appliance and that the power supply is able to with
stand the power consumption (Watts) shown on the
rating plate.
- If using more than one appliance at a time, it is
important to ensure that the power supply is able to
with stand the power requirements.
Free standing operation
Mount the feet on the appliance using the screws provided:
4 x wing screws (E)
Fix the feet with the screws (E), as shown in g.1.
CAUTION: Never use this heater without feet when not wall-
mounted.
Wall-Mounting Installation (optional)
The wall mounting kit contains:
1 x plastic support (F)
2 x metal brackets (G)
2 x 2.9x8 PH (H)
2 x 3.5x20 PH screws (I)
2 x 3.5x35 PH screws (J)
4 x 6x30 plastic anchors (K)
Required tools for assembly and estimated assembly
time
Screwdriver PH 2 x 100 (Phillips type)
Estimated assembly time: 30 minutes
Before installing the unit , make sure of the following:
- The heater is not located directly below a power
outlet.
- The power outlet can be easily reached by the
plug and after installation.
- No electric cables or other pipes could be
damaged during the installation.
- Keep away from curtains or inammable
materials.
Rest the appliance on a at stable surface with the back
facing upwards. Using a screwdriver, x the 2 brackets (G)
with the 2 screws (H) as shown in Fig. 5.
To wall-mount, proceed as follows:
For brick walls use a 6 mm concrete drill bit . For plaster board
or false (hollow) walls, it is recommended to use appropriate
screws and anchors (not supplied).
- Before drilling the wall, mark the exact points,
respecting the minimum distances as shown in g. 3
and g. 4.
- Drill the wall where previously marked, and insert the
plastic anchors (K).
- Fix the support (F) using the two screws provided (J)