manual

10
15min 30min 1h 2h 3h
.
3. Press the ECO button to conrm the selection: auto-o is
programmed.
Please note:
To disconnect the appliance completely, place the main switch
at the back of the appliance in the 0 position (g. 6).
SETTING THE TEMPERATURE
To modify the temperature of the water used to make the
coee, proceed as follows:
1. With the appliance o and the main switch in the I posi-
tion (g. 3), press the button and hold it down until
the lights on the control panel come on.
2. Press the button to select the required tempe-
rature:
LOW HIGH
3. Press the button to conrm the selection. The lights
go o.
ENERGY SAVING
Use this function to enable or disable energy saving mode. En-En-
ergy saving mode reduces energy consumption in compliance
with current European regulations.
To activate or deactivate this mode, press the ECO button. After
a period of inactivity, if ECO mode is active the ECO button light
comes on.
This mode is active by default.
Please note:
A few seconds may elapse between energy saving mode and
delivery of the rst coee.
MAKING COFFEE
Selecting the coee taste
Turn the dial (B9) to select the required taste. Turning it clock- (B9) to select the required taste. Turning it clock-to select the required taste. Turning it clock-. Turning it clock-Turning it clock-
wise increases the quantity of coee beans the appliance will
grind and therefore the strength of the coee obtained.
Please note :
• The rst time you use the appliance, you will need to
make a number of coees to identify the correct dial posi-
tion through trial and error.
• Make sure not to turn the dial too far clockwise, otherwise
the coee may be delivered too slowly (a drop at a time),
particularly when making two cups of coee.
Selecting the quantity of coee in the cup
Select the required quantity of coee (B8) by turning the dial:
Turning it clockwise increases the amount of coee obtained.
Please note :
The rst time you use the appliance, you will need to make a
number of coees to identify the correct dial position through
trial and error.
Adjusting the coee mill
The coee mill is set by default to prepare coee correctly and
should not require regulating initially.
However, if after making the rst few coees you nd that the
coee is either too weak and not creamy enough or delivery is
too slow (a drop at a time), this can be corrected by adjusting
the grinding adjustment dial (g. 7).
Please note :
The grinding adjustment dial must only be turned when the
coee mill is in operation.