Instruction Manual

12
2. After setting the parameters, press
1X
2X
to make 1
cup, or (if possible for the selected beverage)
1X
2X
to
make 2 cups. The appliance starts making the coee and
the image of the selected beverage appears on the display,
together with a progress bar which gradually lls as the
operation proceeds and a description of each individual
phase (grinding, brewing coee);
3. At the end of delivery, the message: "Your beverage is
ready! Save new settings?" is displayed;
4. Press "Save" to save the settings, or "Cancel" to retain the
previous parameters.
Please note!
If you save the new settings, they are memorised ONLY in the
selected prole.
5. "New settings saved on current prole": press "OK" to go
back to the homepage (main screen).
The appliance is ready to be used again.
7.4
Making coee using pre-ground coee
Important!
• Never add pre-ground coee when the machine is o or it
could spread through the inside of the machine and dirty
it. This could damage the machine.
• Never use more than 1 level measure (C2) as it could soil
the inside of the coee machine or block the funnel (A3).
• When using pre-ground coee, only one cup can be made
at a time.
• Making LONG coee: halfway through preparation, the
message "ADD PRE-GROUND COFFEE, MAXIMUM ONE
MEASURE" is displayed. Add one level measure of pre-
ground coee and press "OK".
• You cannot make a DOPPIO+ coee using pre-ground
coee.
1. Lift the pre-ground coee funnel lid (A1)(g. 16);
2. PRE-GROUND LID OPEN. DO YOU WANT TO USE PRE-
GROUND COFFEE?": Press "Next" to proceed (or "Cancel" to
stop and go back to the homepage);
3. "ADD PRE-GROUND COFFEE , MAXIMUM ONE MEASURE":
make sure the funnel (A3) is not blocked, then add one
level measure of pre-ground coee (g. 13).
• Press "OK" to proceed with preparation;
4. "PRE-GROUND MODE" is displayed on the homepage: pro-
ceed as described in section “7.2 Your coee at a touch” or
“7.3 Customising the beverages” above.
Please note!
To exit pre-ground mode, after point 4, open the pre-ground lid
and press "Cancel".
7.5 General indications for making coee-based
beverages
• While the machine is making coee, delivery can be inter-
rupted at any moment by pressing "Stop" or "Cancel".
• Various alarm messages could be displayed while using
the appliance ("FILL TANK WITH FRESH WATER", "EMPTY
GROUNDS CONTAINER", "EMPTY DRIP TRAY" ETC.). Their
meaning is explained in section “22. Displayed messages”.
• If the coee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in sections “6.4
Adjust mill” and “23. Troubleshooting”.
• If "Energy Saving" mode is active, you may have to wait a
few seconds before the rst coee is delivered
7.6 Tips for a hotter coee
For hotter coee, proceed as follows:
• perform a rinse cycle by selecting "Rinsing" in the settings
menu (B6) (section “6.1 Rinsing”);
• warm the cups with hot water using the hot water function
(see section “13. Delivering hot water”);
• increase the coee temperature (section “7.3 Customising
the beverages”).
8. CARAFE OF COFFEE
To make the beverage, press the image on the homepage corre-
sponding to the carafe of coee and proceed as follows:
1. "BEVERAGE SETTINGS": The parameters that can be cus-
tomised according to your tastes appear on the display:
Cups
"Aroma"
Coee type
"Temperature"
2. Position a carafe under the coee spouts (A11). When
choosing the carafe to use, bear in mind the quantity to
be delivered, namely:
Selected quantity Quantity (ml)
250
500
750
3. Press "Next" to move on to the next step;
4. If you select 4 or 6 cups, "The machine will brew 2 (or 3)
times" appears on the display. "Fill water tank and beans
containers if needed": make sure there is sucient water
and coee, then press OK;