Instruction Manual

28
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
NOT ENOUGH COFFEE.
CONSULT MANUAL OR
CUSTOMER SERVICES
The beans present sensor is dirty and not work-
ing correctly
Remove the dust from the sensors using a cot-
ton bud.
If the problem persists, contact De'Longhi Cus-
tomer Services.
GROUND TOO FINE. ADJUST MILL
USING THE DEDICATED FUNCTION
IN MACHINE SETTINGS
The grinding is too ne and the coee is deliv-
ered too slowly or not at all.
Adjust the coee mill (see “6.4 Adjust mill”).
If the water softener lter (C6) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Insert the hot water/steam spout (F) in the ap-
pliance and deliver a little water until the ow
becomes regular. If the problem continues, re-
move the lter (see section “20.3 Removing the
lter”)
SELECT A MILDER TASTE
OR REDUCE PREGROUND
COFFEE QUANTITY
Too much coee has been used. Select a milder "Aroma" (see “7.3 Customising
the beverages”) or reduce the quantity of pre-
ground coee (maximum 1 measure). Press
"OK to go back to the homepage or wait until
the message disappears.
INSERT WATER SPOUT The hot water spout (F) is not inserted or is
inserted incorrectly.
Insert the hot water spout and push as far as it
will go (g. 7): the appliance beeps (if the beep
function is enabled).
INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container and push as far as it
will go (g. 22): the machine emits a beep (if
the beep function is enabled).