Instruction Manual

26
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
INSERT WATER TANK The tank (A25) is not correctly in place. Insert the tank correctly and press as far as it
will go.
CLOSE FRONT DOOR The front door (A16) is open or not closed
correctly.
Close the front door and press until it clicks into
place, the machine emits a beep (if the beep
function is enabled).
STOP FILLING, WATER TANK
FULL
The water tank (A25) is full. Stop lling immediately to avoid water over-
owing from the water tank. Press " OK" to
conrm and go back to the homepage (B).
WATER CIRCUIT EMPTY. PRESS
OK TO START FILLING
The water circuit is empty Place a container with a minimum capacity of
100 ml under the hot water/steam spout (F)
and press "OK" to deliver water. Delivery stops
automatically.
If the problem persists, make sure the water
tank (A25) is fully inserted.
A new water softener lter has been inserted
(C6)
Make sure you have followed the instructions
for inserting the new lter (section “20.1 In-
stalling the lter” and “20.2 Replacing the
lter”). If the problem continues, remove the
lter (section “20.3 Removing the lter”).
INSERT INFUSER ASSEMBLY The infuser (A27) has not been replaced after
cleaning.
Insert the infuser as described in section “17.9
Cleaning the infuser”