Instruction Manual
25
8. "Insert lter in housing and push down fully" (g. 63). Press
"Next";
9. "Insert water tank"
(g. 6): close the tank with the lid
(A24), then put the tank back in the machine and close the
front door. Press "Next";
10. "Position 0.5l container under spouts. Press OK to ll l-
ter": place an empty container with a minimum capacity
of 0.5 litres under the hot water/steam spout (F) (g. 8)
and press "OK".
11. "Rinsing underway. "Hot water from spouts": delivery be-
gins and stops automatically;
12. "Water lter installed": press "OK". The lter is now active
and you can use the coee machine.
20.2 Replacing the lter
Replace the lter (C6) when "REPLACE WATER SOFTENER FILTER,
PRESS OK TO START" appears on the display (B1). To replace the
lter immediately, press "OK" and follow the instructions from
point 6. To replace the lter later, press "Cancel". The symbol
(B9) appears on the display to remind you that the lter needs
replacing.
To replace, proceed as follows:
1. Remove the new lter from the packaging;
2. Press the settings menu (B6);
3. Select "Replace water lter";
4. "Press OK to replace water lter": press "OK" to enter the
guided procedure;
5. "Remove current lter before installing a new one": press
the (A15) button, open the front door (A16) (g. 3) and
extract the water tank (A25) and exhausted lter. Press
"Next" to continue ("Back" to go back to the previous
screen; "Cancel" to cancel the operation);
6. Follow the operations described in the previous section
from point (4).
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
20.3 Removing the lter
If you want to use the appliance without the lter (C6), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Press the button
(A15), open the front door
(A16) (g. 3)
and extract the water tank
(A25) and exhausted lter;
2. Press the settings menu (B6);
3. Select "Remove water lter";
4. "Press OK to conrm lter removal": press OK to conrm;
5. "Filter removed": the change has been saved. Press "OK" to
go back to the homepage (B).
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
21. TECHNICAL DATA
Voltage: 220-240 V~ 50-60 Hz max. 10 A
Power: 1550 W
Pressure: 1.9 MPa (19 bars)
Water tank capacity: 2.1 l
Size LxDxH: 290x468x405mm
Cord length: 1750 mm
Weight: 16.8 kg
Beans container capacity: 290g (x2)
Frequency: 2400/2483.5 MHz
Maximum transmission power 10 mW
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK WITH FRESH
WATER. USE REFILL FUNNEL
OR REMOVE WATER TANK
Insucient water in the tank
(A25)
. Press the button (A15), open the door (A16)
(g. 3), extract the tank and ll with fresh
water, then put back in the appliance and close
the door.
Alternatively, you can top up the tank by pour-
ing the water through the rell door (A23) and
checking the level through the transparent
window in the side of the tank. Important:
never pour water through the rell door
when the tank has been extracted
22. DISPLAYED MESSAGES