Instruction Manual

21
2. Extract the water tank (g. 4), remove the water softener lter
(if present) and rinse it with running water;
3. Empty the water tank and clean with a damp cloth and a little
washing up liquid . Rinse thoroughly with water;
4. Put the lter back in the appliance (g. 63), ll the tank with
fresh water up to the MAX level (marked inside) (g. 5), put the
tank back (g. 6) and close the door;
5. (models with a water softener lter only) Deliver 100ml of hot
water.
17.7 Cleaning the coee spouts
1. Clean the coee spouts
(A17) regularly with a
sponge or the cloth (C9)
provided (g. 48A);
2. Check that the holes in
the coee spout are not
blocked. If necessary, re-
move coee deposits with
a toothpick (g. 48B).
17.8 Cleaning the
pre-ground coee
funnel
Clean the pre-ground coee
funnel (A3) regularly (about
once a month) with a damp
cloth. Proceed as follows:
1. Open the lid (A1) (g. 16);
2. Extract the funnel (g. 49)
and clean with the brush
provided (C5);
3. If necessary, clean the
funnel with hot water and
washing up liquid or in a
dishwasher;
4. Put the funnel back in
the appliance;
5. Close the lid.
17.9 Cleaning the infuser
The infuser (A27) must be cleaned at least once a month.
Important!
The infuser cannot be extracted when the machine is on.
48B
48A
49
50 51
1. Make sure the machine is correctly turned o (see “5. Turn-
ing the appliance o”);
2. Press the button (A15), open the door (A16) and extract
the water tank (A25) (g. 4);
3. Open the infuser door (A26) (g. 50) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 51);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID  NO DISHWASHER
6. Clean the infuser without using washing up liquid as it
could be damaged.
7. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
8. After cleaning, put the infuser back in the appliance, in-
serting it in the support (g. 52);
52 53
9. Once inserted, make sure the two coloured buttons have
snapped out (g. 53);
10. Close the infuser door;
11. Put the water tank back and close the front door.