Instruction Manual

20
• Do not use metal objects to remove encrustations or coee
deposits as they could scratch metal or plastic surfaces.
17.2 Cleaning the internal circuit
If the appliance is not used for more than 3/4 days, before using
it again, we strongly recommend switching it on and perform-
ing 2/3 rinse cycles by selecting the "Rinse" function (section
“6.1 Rinsing”) with the hot /steam water spout (F) attached to
the appliance.
Please note!
After cleaning, it is normal for the grounds container (A18) to
contain water.
17.3 Cleaning the coee grounds container
When "EMPTY GROUNDS CONTAINER" appears on the display
(B1), the grounds container must be emptied and cleaned. The
appliance cannot be used to make coee until you have cleaned
the grounds container (A18). Even if not full, the empty grounds
container message is displayed 72 hours after the rst coee has
been prepared. For the 72 hours to be calculated correctly, the
machine must never be turned o with the main switch (A12).
Important! Danger of scalding
If you make a number of milk-based beverages one after the
other, the metal cup tray (A19) becomes hot. Wait for it to cool
down before touching it and handle it from the front only.
To clean (with the machine on):
1. Press the button (A15) and open the front door (A16) (g.
3);
2. Remove the drip tray (A22) and grounds container (A18)
(g. 45);
3. Empty the grounds con-
tainer and clean thor-
oughly to remove all res-
idues left on the bottom.
This can be done using
the spatula on the brush
(C5) provided.
4. Put the drip tray complete
with grille and grounds
container back in the
appliance, then close the
front door.
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds. If this is not done,
when you make the next coees, the grounds container may ll
up more than expected and clog the machine.
45
17.4 Cleaning the drip tray and drip tray grille
Important!
The drip tray (A22) is tted
with a level indicator (red)
showing the amount of water
it contains (g. 46). Before the
indicator protrudes from the
cup tray (A19), the drip tray
must be emptied and cleaned,
otherwise the water may
overow the edge and dam-
age the appliance, the surface
it rests on or the surrounding
area. To remove the drip tray,
proceed as follows:
1. Press the button (A15) and open the front door (A16) (g.
3);
2. Remove the drip tray and coee grounds container (A18)
(g. 45);
3. Remove the cup tray (A19) and drip tray grille (A21), then
empty the drip tray and grounds container and wash all
components.
4. Put the drip tray complete with grille and grounds contain-
er back in the appliance, then close the front door.
17.5 Cleaning the inside of the machine
Danger of electric shock!
Before cleaning internal parts,
the machine must be turned
o (see section “5. Turning the
appliance o”) and unplugged
from the mains power supply.
Never immerse the machine
in water.
1. Regularly (about once
a month), check that
the inside of the appli-
ance (accessible after
pressing the button
(A15), opening the front
door (A16) (g. 3) and
removing the drip tray (A22)) is not dirty. If necessary, re-
move coee deposits with the brush (C5) supplied and a
sponge.
2. Remove all residues with a vacuum cleaner (g. 47).
17.6 Cleaning the water tank
Clean the water tank (A25) regularly, about once a month and
whenever you replace the water softener lter (C6).
1. Press the button
(A15)
and open the door
(A16) (g. 3);
46
47