User manual

Min 4 sec
> 6 sec
EN
FR
21
Reset to Factory Settings
Emptying the System
before a period of non-use or for frost protection
Factory settings are:
- Lungo, Espresso, Ristretto coffee buttons 110ml /
3.7oz, 40ml / 1.35 oz., 25ml / 0.84 oz.
- Automatic OFF mode after 9 minutes.
- The water hardness set by default is hard, which
corresponds to around 1000 Espresso cups.
To do it via your machine:
1. Ensure the machine is turned OFF.
2. Press and hold Espresso & Lungo buttons for at least
5 seconds.
All the coffee buttons and LEDs will blink once as
confirmation. To unpair your machine, please refer to
the «Troubleshooting section».
If reset to factory setting, this
will cancel the pairing, reset the
capsules stock management and
the descaling alert.
Remove the water tank.
Place a container under
the coffee outlet.
To note, the machine remains blocked for 10 minutes after emptying!
Ensure the machine
is ON, press and hold
the Ristretto & Lungo
buttons together for
at least 6 seconds.
The Ristretto and Lungo coffee buttons will flash for
confirmation. Then close the slider to start procedure. If the slider
was already closed, the emptying process starts automatically. When
the procedure is finished, clean the drip tray and the cup support.
Machine turns to OFF mode automatically when empty.
Reset to Factory Settings /
Emptying the System
before a period of non-use or for frost protection /
 Factory settings are:
- Lungo, Espresso, Ristretto coffee buttons 110ml /
3.7oz, 40ml / 1.35 oz., 25ml / 0.84 oz.
- Automatic OFF mode after 9 minutes.
- The water hardness set by default is hard, which
corresponds to around 1000 Espresso cups.
To do it via your machine:
1. Ensure the machine is turned OFF.
2. Press and hold Espresso & Lungo buttons for at least
5 seconds.
All the coffee buttons and LEDs will blink once as
confirmation. To unpair your machine, please refer to the
«Troubleshooting section».
If reset to factory setting, this
will cancel the pairing, reset the
capsules stock management and
the descaling alert.
 Remove the water tank.
Place a container under
the coffee outlet.
To note, the machine remains blocked for 10 minutes after emptying!
 Ensure the machine
is ON, press and hold
the Ristretto & Lungo
buttons together for
at least 6 seconds.
 The Ristretto and Lungo coffee buttons will
flash for confirmation. Then close the slider to
start procedure. If the slider was already closed,
the emptying process starts automatically. When
the procedure is finished, clean the drip tray and
the cup support. Machine turns to OFF mode
automatically when empty.
Job: NES-432001-2003Q-3 ProdigioMilk
Datum: 15-06-05
von: timea.trojko
Uhrzeit: 15:03:43
Seite: q19
Version: --
qInletObjekt: