User Instructions

21
FILL BEANS CONTAINER The coee beans have run out. Fill the beans container (g. 14).
The pre-ground coee funnel (A4) is clogged. Empty the funnel with the help of a brush as
described in the section “Cleaning the pre-
ground coee funnel” (page 16).
INSERT INFUSER ASSEMBLY The infuser (A15) has not been replaced after
cleaning.
Insert the infuser as described in the para-
graph “Cleaning the infuser” (page 16).
INSERT TANK The tank (A16) is not correctly in place. Insert the tank correctly and press as far as it
will go.
GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in the section “Cleaning” (page
15). If the message is still displayed after
cleaning, contact a service centre.
EMPTY CIRCUIT, FILL CIRCUIT
HOT WATER
Press OK
The water circuit is empty Press OK (B3) and deliver water from the spout
(D4), until it ows out normally.
REPLACE FILTER The water softener lter is exhausted. Replace the lter or remove it as described in
the section “Water softener lter” (page 20).
SET DIAL TO CLEAN Milk has been delivered recently and the tubes
inside the milk container must be cleaned.
Turn the froth adjustment dial to CLEAN (g.
25).
INSERT WATER SPOUT The hot water spout is not inserted or is
inserted incorrectly.
Insert the water spout (D4) as far as it will go.
INSERT MILK CONTAINER The milk container is not inserted correctly. Insert the milk container (g. 23) as far as it
will go.
PROBLEM POSSIBLE CAUSE SOLUTION
The coee is not hot The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The infuser has cooled down because
2/3 minutes have elapsed since the last
coee was made.
Before making coee, use the special function
to rinse and heat the infuser
(page 10)
.
A low coee temperature is set.
Set a higher coee temperature in the menu
(page11).
TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.