User Instructions

19
Please note
The lter lasts about two months if the appliance is used nor-
mally. If the coee machine is left unused with the lter in-
stalled, it will last a maximum of three weeks.
3. To activate the lter, run tap water through the hole in the
lter as shown in the gure until water comes out of the
openings at the side for more than a minute (g. 42).
4342
0,5 L
4. Extract the tank from the appliance and ll with water.
5. Insert the lter in the water tank and immerse it complete-
ly for about ten minutes, sloping it and pressing it lightly to
enable the air bubbles to escape (g. 43).
6. Insert the lter in the lter housing (g. 44A) and press as
far as it will go.
7. Close the tank with the lid (g. 44B), then put the tank
back in the machine.
44A 44B
When you install the lter, you must notify the appliance of its
presence.
8. Press the MENU/ESC button (B2) to enter the menu;
9. Press or (g. 9) until “Install lter” is displayed;
10. Press the OK button (g. 3).
11. “Enable?” is displayed.
12. Press the OK button to conrm the selection. “HOT WATER
Press OK” is displayed.
13. Position a container under the hot water spout (min. ca-
pacity: 500 ml).
14. Press the OK button to conrm the selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed.
15. After delivery, the appliance is automatically ready to make the
next drink.
The new lter is active. You can now use the appliance.
Replacing the lter
When “REPLACE FILTER” is displayed, after two months (see date
indicator) or when the appliance has not been used for 3 weeks,
you should replace the lter:
1. Extract the tank and exhausted lter;
2. Take the new lter out of its packet and proceed as illus-
trated in points 2-3-4-5-6-7 in the previous section.
3. Position a container with a minimum capacity of 500 ml
under the hot water spout.
4. Press the MENU/ESC button (B2) to enter the menu.
5. Press < or > (g. 9) until “Replace lter” is displayed.
6. Press the OK button (g. 3);
7. “Conrm?” is displayed.
8. Press the OK button to conrm the selection;
9. “HOT WATER Press OK” is displayed.
10. Press the OK button to conrm the selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed.
11. After delivery, the appliance is automatically ready to
make the next drink.
The new lter is now active and you can use the coee machine.
Removing the lter
If you want to use the appliance without the lter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Extract the tank, remove the lter and put the tank back in
the machine.
2. Press the MENU/ESC button (B2) to enter the menu;
3. Press or (g. 9) until “Install lter, Enabled” is
displayed;
4. Press the OK button (g. 3);
5. “Disable?” is displayed;
6. Press the OK button to conrm and the MENU/ESC button
to exit the menu.
TECHNICAL DATA
Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power: 1450W
Pressure: 15 bar
Max. water tank capacity: 2 l
Size LxHxD: 260 x 360 x 460 mm
Cable length: 1,75 m
Weight: 10,9 kg
Coee beans container capacity: 400 g