User Instructions

16
• Extract the drip tray (g. 27), empty and clean.
• Empty the grounds container (A10) and clean thoroughly
to remove all residues left on the bottom. This can be done
with the spatula on the brush provided (D2).
• Check the condensate tray (A9) and empty if necessary (g.
28).
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coees, the grounds
container may ll up more than expected and clog the machine.
Cleaning the drip tray and condensate tray
Important!
The drip tray (A12) is tted with a level indicator (red) showing
the level of water it contains (g. 29).
Before the indicator protrudes from the cup tray, the drip tray
must be emptied and cleaned, otherwise the water may over-
ow the edge and damage the appliance, the surface it rests on
or the surrounding area.
To remove the drip tray:
1. Extract the drip tray (A12) and grounds container (g. 27);
2. Empty the drip tray and grounds container (A10) and wash
them;
3. Check the condensate tray (A9) and empty if necessary;
4. Replace the drip tray complete with grounds container.
Cleaning the inside of the coee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see “Turning o”) and unplugged from the mains power sup-
ply. Never immerse the coee machine in water.
1. Check regularly (about once a week) that the inside of the
appliance (accessible after removing the drip tray) is not
dirty. If necessary, remove coee deposits with the brush
supplied (D2) and a sponge.
2. Remove the residues with a vacuum cleaner (g. 30).
Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month
and whenever you replace the water softener lter (if pres-
ent) with a damp cloth and a little mild washing up liquid.
2. Remove the lter (if present) and rinse with running water.
3. Replace the lter (if present), ll the tank with fresh water
and replace the tank.
Cleaning the coee spouts
1. Clean the coee spouts regularly with a sponge or cloth
(g. 31).
2. Check the holes in the coee spout are not blocked. If nec-
essary, remove coee deposits with a toothpick (g. 31).
Cleaning the pre-ground coee funnel
Check regularly (about once a month ) that the pre-ground cof-
fee funnel (A4) is not blocked.
If necessary, remove coee deposits with the brush (D2)
supplied.
Cleaning the infuser
The infuser (A15) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “Turning
o”, page 10).
2. Extract the water tank (g. 4).
3. Open the infuser door (g. 32) on the right side of the
appliance.
33
PUSH
4. Press the two red release
buttons inwards and at the
same time pull the infuser
outwards (g. 33).
5. Soak the infuser in water for
about 5 minutes, then rinse
under the tap.
Important!
RINSE WITH WATER ONLY NO WASHING UP LIQUID  NO
DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (D2) to remove any coee residues left in the
infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 34), then push the PUSH symbol fully
in until it clicks into place.
34
Infuser
support