User Instructions

13
• Various alarm messages could be displayed while using
the machine (FILL TANK, EMPTY GROUNDS CONTAINER,
etc.). Their meaning is explained in the section “Displayed
messages” (page 20).
• For hotter coee, see the section “Tips for a hotter coee”
(page 12).
• If the coee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in the “Trouble-
shooting” section on page 21.
Making coee using pre-ground coee
Important!
• Never add pre-ground coee when the machine is o or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
• Never use more than one level measure or it could dirty the
inside of the machine or block the funnel.
Please note!
If you use pre-ground coee, you can only make one cup of
coee at a time.
1. Press the
button (g. 10) repeatedly until “Pre-
ground” is displayed.
2. Open the lid of the pre-ground coee funnel (A2).
3. Make sure the funnel is not blocked, then add one level
measure of pre-ground coee (g. 17).
4. Place a cup under the coee spouts (g. 12).
5. Press the 1 cup button (g. 16).
6. Preparation begins. The amount of coee selected is dis-
played together with a progress bar which gradually lls as
preparation progresses.
Please note!
If “Energy saving” mode is active, you may have to wait a few
seconds before the rst coee is delivered.
Making LONG coee using coee beans
Follow the instructions in the section “Making coee using cof-
fee beans” to prepare the machine, then press the button
(g. 18).
Making LONG coee using pre-ground coee
Follow the instructions in points 1, 2, 3 and 4 of the section
“Making coee using pre-ground coee”, then press the
button (g. 18).
The appliance starts making coee and displays a progress bar.
Halfway through preparation, the message “ADD PRE-GROUND
COFFEE, Press OK” appears. Add one level measure of pre-
ground coee and press OK (g. 3).
Preparation resumes and the appliance displays a progress bar
which lls gradually as preparation proceeds.
Customising the LONG coee quantity
The appliance is set by default to automatically deliver about
200 ml of LONG coee.
To modify these settings, proceed as follows:
1. Place a suciently large cup or glass under the coee
spouts (g. 12).
2. Press and hold the
button (g. 18) until “Program
quantity” is displayed.
3. Release the button. The appliance starts delivering
coee;
4. As soon as the coee in the cup reaches the required level,
press the button again.
The quantity of coee in the cup has now been programmed.
Please note!
If the programme uses pre-ground coee, the appliance will
prompt you to add a second level measure of coee.
MAKING CAPPUCCINOS AND MILK BASED COFFEES
Please note!
• To avoid producing milk with poor froth or large bubbles,
always clean the milk container lid and hot water connec-
tion nozzle as described in the section “Cleaning the milk
container” on pages 14 and 17.
Filling and attaching the milk container
1. Remove the lid (g. 19);
2. Fill the milk container with a sucient quantity of milk,
not exceeding the MAX level marked on the handle (g.
20). Each mark on the side of the container corresponds to
around 100 ml of milk.
Please note!
• For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
• If “Energy saving” mode is enabled, you may have to wait a
few seconds before the rst coee is delivered.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (g. 21).
4. Place the lid back on the milk container.
5. Remove the hot water spout (D4), (g. 22).
6. Attach the milk container to the connection nozzle and
push as far as it will go (g. 23). The machine emits a beep
(if the beep function is enabled).