Instruction Manual

15
45
46
Insert the burr in its housing (g. 45);
Turn the selector to select the desired grinding level (g. 46);
Make sure the burr is inserted correctly by pulling it by the
handle. If it is correctly inserted, it will not move;
9. Use a brush to remove any coee residues from the outlet
of the coee grinder (A22).
13.9 Replacing the burrs
Over time, the burrs will wear down. If you are unable to achieve
the ideal quantity of coee outlined in section "4.5 Adjusting the
quantity of ground coee in the lter", contact De'Longhi Cus-
tomer Service (see "www.delonghi.com").
13.10
Cleaning the "Sm
art tampi
ng station"
To guarantee top quality grinding, clean the “Smart tamping
station regularly as follows:
47 48
1. Clean the attachment area with a brush (g. 7).
2. Pull the
lever
(A23) as far as it will go and clean the presser
cylinder with a brush (g. 48). Then release the lever.
3. Use the tube brush (C8) to clean the coee guide (g. 49).
13.11 Other cleaning
operations
1. Do not use solvents or
abrasive detergents to
clean the coee maker.
Use a soft damp cloth only.
2. Clean the portalter cup.
3. You are recommended to
use De’Longhi detergent.
14. DESCALING
Descale the appliance when the light (B9) comes on.
Before use, read the instructions and the labelling on the
descaler pack.
It is important to use De’Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may result in
faults not covered by the manufacturer's guarantee.
Proceed as follows:
1. IF PRESENT, REMOVE THE WATER SOFTENER FILTER.
Pour
the descaler into the tank up to the level
A marked
inside the tank (equal to one 100ml/3.3  oz packet), then
add water (litre) up to the level
B .
2. If the appliance is o, press the ON/Standby button (B1).
3. Make sure the portalter is not attached and position a
recipient under the spouts (A5), (A6) and the boiler outlet
(A21)
(g. 8).
4. Turn the mode selector dial (B8) to the position. The
light ashes and the "OK" light comes on.
5. Press "OK" (B5) to start descaling.
6. The descale programme starts and the descaler liquid comes
out of the spouts and boiler outlet. The descale programme
removes limescale deposits from inside the appliance by au-
tomatically performing a series of rinses and pausesuntil the
tank is empty.
7. Delivery stops and the (B15) and lights corre-
sponding to the rinse button (B4) come on.
8. Empty the recipient used to collect the descaler solution
and replace it empty under the spouts.
9. Remove the water tank, empty any residues of descaler
solution, rinse with running water and ll with fresh water
up to the MAX level. Put the tank back in its housing.
49