instructions Coffee Maker EC190 Please retain these instructions for future reference
-cup filter 1-cup filter Filter holder Steam release knob Lid for water tank Water tank Steam nozzle Coffee tamper Milk frother Removable drip tray black area inside for positioning cups Boiler outlet Boiler "ON" function Coffee measuring spoon "O" OFF position OK/Ready light (coffee/water or steam) Steam function (for milk frothing) Espresso function Selector dial Coffee Maker 2
Thank you for choosing this coffee machine. To get the very best out of your new coffee machine it is advisable to read these instructions before using the appliance. This is the only way to ensure optimum results and maximum safety. Using for the first time Before using the machine for the first time, wash all the accessories in warm soapy water and rinse. For the best tasting coffee the internal circuits must be flushed through at least five times.
How to prepare espresso coffee Filling the water tank To remove the water tank lift the lid (fig.2) and simply pull upwards (fig 3) and fill the tank at the sink (fig 4). Do not exceed the MAX level on the water tank. The tank may also be filled without removing it, simply by pouring water into it directly from a jug. Replace the tank by connecting the valve at the bottom of the tank with the hole in the base on the machine.
How to prepare espresso coffee 1. After carrying out the preheating of the machine as described in the preceding section, in order to make just one cup of espresso coffee, insert the 1-cup filter (the smaller of the two provided) into the filter holder (Fig. 9) and fill it with one level measuring spoon of ground coffee (fig. 10) – about 7 grams.
How to make cappuccino 1. Prepare espresso coffee, using cups that are large enough for cappuccinos 2. Turn the selector knob to the position (fig. 15) and wait until the “OK” light comes on (fig. 7) to indicate that the boiler has reached the ideal temperature for producing steam. 3. Meanwhile, fill a heat resistant container/jug with approximately 3fl. oz. of milk for each cappuccino.The milk should be cooled from the refrigerator and semi-skimmed as this gives the best results.
Producing hot water 1. Turn on the coffee unit by turning the selector knob to the boiler “ON” position (fig. 5). 2. Position a container under steam nozzle. 3. When the ‘OK’ light comes on, position the selector at (fig. 7) and at the same time turn the steam knob in an anticlockwise direction (fig. 17); hot water will come out from the steam nozzle. 4. To stop the flow of hot water, turn the steam knob in a clockwise direction and position the selector knob at boiler “O” position (fig. 14). fig.
Descaling It is advisable to clean the calcium from the machine every 200 cups of coffee. It is recommended that specific (store-bought) products for descaling of espresso coffee machines be used. If such products are not available, it is possible to proceed as follows: 1. Fill the tank with water using 1 litre of water; 2. Dissolve 2 spoonfuls (about 30 grams) of citric acid in the water (available from chemists); 3. Turn the selector knob to the position and wait until the ‘OK’ light comes on. 4.
Problem solving PROBLEM POSSIBLE CAUSES SOLUTION • • Lack of water in the tank. The holes in the filter holder are blocked. The outlet of the espresso boiler is blocked. • • • The tank is badly inserted and the valve at the bottom is not open. • • The filter holder is badly inserted. • • The gasket of the espresso boiler has lost elasticity. The holes in the filter holder are blocked. • The ‘OK’ pilot light was not on when the coffee delivery switch was pressed.
PROBLEM POSSIBLE CAUSES SOLUTION • The ground coffee is too tightly pressed. The quantity of ground coffee is too much. The espresso boiler outlet is blocked. • Press the coffee less. • • The coffee is too finely ground. • Decrease the quantity of ground coffee. Clean the outlet as described in “Cleaning the espresso boiler outlet” section. Only use coffee specifically ground for espresso coffee machines. The coffee has an acidic taste.
Safety Warnings • This machine has been built to make coffee and to reheat beverages; please be careful to avoid burns from the sprays of hot water or steam and avoid any improper use. • When the appliance is in use, do not touch any of the machine’s hot surfaces. • After unpacking, make sure that the machine is complete and undamaged. In case of doubt, do not use the appliance and seek the advice of a qualified service professional. • Packaging materials (plastic bags, foam polystyrene, etc.
Green and Yellow to Earth 13 amp Fuse Brown to Live Blue to Neutral Cord Clamp Electrical requirements Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.