COFFEE MAKER Instruction for use Please retain instructions for future reference EC152.
Electrical requirements Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.
Description OFF position Steam position OK indicator light On indicator light Coffee- hot water delivery position Water tank Water tank lid Steam dial Filter compartment Power supply cable Selector dial Coffee tamper Steam or hot water tube Drip tray Cappuccino nozzle Boiler outlet Filter Filter holder Measure 3
fig. 2 fig. 3 fig. 4 fig. 5 fig. 6 fig. 7 fig. 8 fig. 9 fig. 10 fig. 11 fig. 12 fig.
fig. 13 fig. 14 fig. 15 fig. 16 fig. 17 fig. 18 fig. 19 fig. 20 fig. 21 fig. 22 fig. 24 fig. 23 fig. 25 fig.
Safety Symbols used in these instructions to the enclosed guarantee leaflet for details. The important recommendations have these symbols. These recommendations must be followed. Attention: Keep the packaging material (plastic bags, expanded polystyrene) out of the reach of children. Danger! Failure to comply can be or is the cause of injury due to life-threatening electric shocks.
Introduction Instructions for use Thank you for choosing this coffee machine. To get the very best out of your new coffee machine it is advisable to read these instructions before using the appliance. This is the only way to ensure optimum results and maximum safety. The manufacturer is not liable for damage deriving from the failure to comply with the user instructions. Only connect the appliance to a correctly installed socket with a minimum rating of 10A and correctly earthed.
Making espresso Making espresso Please Note: first use Before using the appliance for the first time, rinse the internal piping thoroughly, operating it as you would to make coffee, until two tanks of water have emptied, then proceed with making coffee. 3. 4. Pre-heating the coffee machine 1. Turn the appliance on by rotating the selector dial to the position (the relative indicator light switches on) (fig. 4) and attach the filter-holder with the empty filter to the machine (fig. 5).
Cappuccino To switch off the appliance, turn the selector dial to the position. 9. Pour the frothed milk into the cups containing the previously prepared espresso coffee. The cappuccino is ready. Add sugar and sprinkle a little powder chocolate on top of the froth if desired. Making a cappuccino 1. Prepare the espresso coffee as described in the previous paragraphs, using cups that are large enough 2. Rotate the selector dial to the position (fig. 13). 3.
Hot water • Cleaning Producing hot water 1. Switch the machine on by turning the selector dial to the position (the relative light comes on) (fig. 4). Wait for the OK light to switch on (fig. 7). 2. Position a container under the cappuccino nozzle. 3. When the OK light comes on, turn the selector dial to the position (fig. 8) and turn the steam dial anti-clockwise at the same time (fig. 16). The hot water will be delivered from the cappuccino nozzle. 4.
Descaling · Disposal Descaling It is recommended to descale the machine about every 200 coffees. Follow this procedure: 1. Fill the tank with the descaling solution obtained by diluting the descaler with water following the indications given on the pack. 2. Switch the appliance on by turning the selector to the position and wait until the OK indicator light comes on. 3. Make sure that the filter holder is not attached and position a suitable container under the machine outlet. 4.
Troubleshooting Problem Possible causes Solution Espresso coffee does not flow out No water in the tank Fill the water tank The holes in the filter-holder are blocked Clean the holes in the filter-holder spouts The espresso boiler outlet is blocked Clean as indicated in the “Cleaning the boiler outlet” paragraph The filter-holder is inserted incorrectly Attach the filter-holder correctly and turn it fully to the right The espresso boiler gasket has lost elasticity Replace the espresso boiler ga
