Technical data

10
PRELIMINARY CHECKS
Checking the appliance
After removing the packaging, make sure the product is
complete and undamaged and that all accessories are present.
Do not use the appliance if it is visibly damaged.
Contact De’Longhi Customer Services.
Installing the appliance
Important!
When you install the appliance, you should respect the
following safety warnings:
• Theappliancegivesoheat.
After positioning the appliance on the worktop, leave
a space of at least 3 cm between the surfaces of the
appliance and the side and rear walls and at least 15 cm
above the coee machine.
• Waterinltrationcoulddamagetheapplianceandcause
electric shock.
Do not place the appliance near taps or sinks.
• Theappliancecouldbedamagedifthewateritcontains
freezes.
Do not install the appliance in a room where the
temperature could drop below freezing point.
• Arrangethepowercableinsuchawaythatitcannotbe
damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connecttheappliancetoanecientlyearthedandcorrectly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Using the appliance for the rst time
Please note :
• Coeehasbeenusedtofactorytesttheapplianceandit
is therefore completely normal for there to be traces of
coee in the grinder.
The machine is, however, guaranteed to be new.
• Youshouldcustomisewaterhardnessassoonaspossible
following the instructions in the section “Setting water
hardness” (page 20).
1. Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(g. 1).
You must rst choose the language (the languages scroll
through at intervals of about 3 seconds):
2. When “English” appears, press the OK icon (g. 2) or a
few seconds until “English set” is displayed.
Follow the instructions indicated by the appliance:
3. FILL WATER TANK!”: remove the
water tank, ll to the MAX line with
fresh water then replace in the
appliance (g. 3).
4. INSERT WATER SPOUT”: Check that
the hot water spout is inserted on
the nozzle and place a container
with a minimum capacity of 100 ml
underneath (g. 4).
5. PRESS OK”: press the OK icon on the display.
6. The appliance starts delivering water from the hot water
spout.
7. The appliance ends the rst start up procedure and goes
o automatically.
The coee machine is now ready for normal use.
Please note:
• Whenusingtheapplianceforthersttime,youneedto
make 4-5 cups of coee or 4-5 cappuccinos before it starts
to give satisfactory results.
TURNING THE APPLIANCE ON
Please note:
Before turning the appliance on, make sure the main switch on
the back of the appliance is in the I position (g. 1).
Each time the coee machine is turned on, it performs an
automatic preheat cycle and, if necessary, a rinse cycle which
cannot be interrupted. The appliance is ready for use only after
completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath. Avoid contact with
splashes of water.
• Toturntheapplianceon,pressthe button for a few
moments (g. 5):
The message “Heating up, please wait” is
displayed.