Technical data
21
5. Press the ESC icon to exit the menu.
The machine is now reprogrammed with the new water
hardness setting.
WATER SOFTENER FILTER
Certain models are tted with a water softener lter. If this
is not the case with your model, you are recommended to
purchase one from De’Longhi Customer Services. To use the
lter correctly, follow the instructions below.
Installing the lter
1. Remove the lter from the packaging.
2. Turn the date indicator
disk until the next
two months of use are
displayed.
Please note
The lter lasts about two
months if the appliance is
used normally. If the coee
machine is left unused with
the lter installed, it will last a
maximum of three weeks.
3. To activate the lter, let
tap water go in the hole
of the lter as shown in
the gure as long as the
water comes out from
the side openings for
over one minute.
4. Extract the tank from the
appliance and ll with
water.
5. Insert the lter in the
water tank and immerse
it completely for about
30 seconds, turning it
upside down to enable
the air bubbles to
escape.
6. Insert the lter in the
lter housing and press
as far as it will go.
7. Close the tank with the
lid, then put the tank
back in the machine.
When you install the lter, you must notify the appliance of its
presence.
8. Access the menu by pressing the MENU icon;
9. Scroll through the menu by pressing the or icon
until “Install water lter” is displayed.
10. Press the OK icon.
11. The message “Install water lter” “CONFIRM?” is
displayed.
12. Press the OK icon to conrm the selection. The message
“INSERT WATER SPOUT” “PRESS OK” is displayed.
13. Position a container under the hot water spout (min.
capacity: 100 ml).
14. Press OK to conrm the selection. The appliance begins
delivering hot water and “Please wait” is displayed.
15. After delivery, the appliance is automatically ready to make
the next drink.
The lter is now active and you can use the coee machine.
Replacing the lter
When the lter alarm is displayed, after two months
(see date indicator) or if the appliance has not been
used for 3 weeks, you should replace the lter:
1. Extract the tank and exhausted lter;
2. Remove the new lter from the packaging and proceed as
illustrated on the previous pragraph (points 3-4-5-6).
3. Position a container with a minimum capacity of 100 ml
under the hot water spout.
4. Access the menu by pressing the MENU icon;
5. Scroll through the menu by pressing the or icon
until “Replace water lter” is displayed.
6. Press the OK icon.
7. “CONFIRM?” is displayed.
8. Press the OK icon to conrm.
9. “Water delivery” “PRESS OK” is displayed.
10. Press OK to conrm the selection. The appliance begins
delivering hot water and “Please wait” is displayed.
11. After delivery, the appliance is automatically ready to make
the next drink.
The new lter is now active and you can use the coee
machine.
Removing the lter
If you want to use the appliance without the lter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Extract the tank and exhausted lter.
2. Put the tank back in the appliance.
3. Access the menu by pressing the MENU icon.
4. Scroll through the menu by pressing the or icon
until “Remove water lter” is displayed.
5. Press the OK icon.
6. “CONFIRM?” is displayed;