Technical data

19
Please note!
It is normal to nd residues on the stirrer while cleaning. These
consist of traces of iron in the cocoa attracted by the magnets
in the stirrer.
Cleaning the milk container (C)
Clean the milk container each time you prepare milk as
described below:
1. Lift and remove the
lid (C1);
2. Extract the milk
container (C5) from
the thermal casing
(C6), holding it by
the two side grips.
Important!
The thermal casing must not
be lled with or immersed in
water. Clean with a damp cloth
only.
3. Remove the milk spout (C3)
and intake tube (C5).
4. Turn the froth adjustment
dial clockwise to the
“INSERT” position (see
gure) and pull o.
5. Wash all the components
of the frother thoroughly
with hot water and mild
washing-up liquid.
All components and the
container are dishwasher safe, placing them in the top
basket of the dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (see gure alongside). If necessary,
scrape the groove with a toothpick.
6. Rinse inside the froth adjustment dial seat with running
water (see gure) and the hole that connect the lid to the
appliance.
7. Check that the intake tube and spout are not clogged with
milk residues.
8. Replace the dial (lining up the arrow with the word
“INSERT”), the spout and the milk intake tube.
9. Place the milk container in the thermal casing.
10. Place the lid back on the milk container.
Important!
RINSE WITH WATER ONLY NO WASHING UP LIQUID  NO DISH
WASHER
Do not use washing up liquid to clean the infuser as it could
cause damage.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. After cleaning, replace the infuser by sliding it onto the
internal support and pin at the bottom, then push the
PUSH symbol fully in until it clicks into place.
Please note!
If you encounter diculty
inserting the infuser, before
inserting it you must adapt it to
the right dimension by pressing it
forcefully from the bottom and
top as shown in the gure.
7. Once inserted, make sure the two red
buttons have snapped out.
8. Replace the drip tray and grounds
container.
9. Close the service door.
Cleaning the hot chocolate carafe (D)
Clean the carafe each time you prepare milk as described
below:
1. Lift and remove the lid (D1);
1
2
2. Remove the funnel (D2) by
pressing the release button
(D6) and lifting it ;
3. Extract the steam spout
(D3) and stirrer (D4);
4. Wash all the components
thoroughly with hot water
and mild washing-up
liquid.
All components are dishwasher safe, placing them
in the top basket of the dishwasher.
5. Replace all the components.