UK VITROCERAMIC HOB Operating instructions book
DHHS80 Ceramic Hob Instructions CAUTION: • In order to avoid a hazard this appliance must be installed according to these installation instructions WARNING: • This appliance is to be installed only by an authorized person • This appliance must be used only for the task it has explicitly been designed for, that is for cooking foodstuffs. Any other form of usage is to be considered as inappropriate and therefore dangerous.
150mm above the hob for the full dimension (width or depth) of the cooking surface area. • Protection of combustible surfaces – The required protection shall ensure that the surface temperature of the combustible surface does not exceed 50°C above ambient. The fixing of 5mm thick ceramic tiles to the surface or attaching fire resistant material to the surface and covering with sheet metal with minimum thickness of 0.4mm would satisfy this requirement.
ELECTRICAL REQUIREMENTS: If you wish a direct connection to the line, it is necessary to interpose a single-pole switch, with a minimum opening between the contacts of 3 mm, suitable for the load indicated in the plate and in conformity with the rules in force (the yellow/green ground cable should not be interrupted by the switch). The single pole switch should be easily accessible with appliance installed. WARNING: • THIS APPLIANCE MUST BE EARTHED.
HOTPLATES: The heating elements are formed by a coil of resistant material which reaches the working temperature quickly. Warning for the eyes: Do not stare at the hotplates when they are on. TOUCH CONTROL OPERATION: i) The very first time power is connected to the cook-top, it will be in locked mode for safety. ii) To begin any operation, touch the lock key for 3 seconds. iii) To turn on an element, touch the corresponding on/off key. The power level indicator LED at position 5 will flash.
· ·Please turn the appliance off at the mains and call your nearest DeLonghi Service Agent. ·Do not lean over the cooking plate when in use. ·Follow the cleaning instructions carefully. ·Always ensure the base of your sausepan is clean & dry before placing on the hob. ·Never use the glass surface for storage. ·Do not scratch the cooktop with cutting utensils or sharp objects. Do not use the glass ceramic cooktop as a work surface.
Only pans recommended for use on ceramic hobs should be used. Pans made of the following materials can cause problems: Cast Iron - The base may be rough which will scratch the hob. Toughened Glass - If the pan becomes too hot, the hob may overheat causing the safety cut out to operate too frequently thus reducing the cooking efficiency. Copper - Can easily distort and will therefore not form a good contact between base and hob which will result in uneven cooking.
TOUCH CONTROL PANEL DESCRIPTION Fig.
TECHNICAL SPECIFICATIONS Voltage 220-240V ~ 50 Hz Max. power 6.7 kW Hotplate (front left) 2100W Hotplate (back left) 1200W Hotplate (back right) 2200W Hotplate (front right) 1200W Touch Control Residual heat indicator warning LED’s Glass overheat cut-out device 1 DIMENSIONS (Note: Also refer to Fig.
94000STISPE0DG_18/06/2002
