Instruction Manual

12
pliance operate by alternating dehumidication cycles and fan
only cycles, thus avoiding the formation of frost. For frequent
use in cold environments, it is recommended to heat the room
at the same time, even slightly. This allows the dehumidier to
operate in conditions that ensure better performance and faster
dehumidication.
Please note!
• The appliance is equipped with a security device
(delay of 3 minutes) that protects the compressor
against too frequent starts and stops.
• When started up, or when power is restored, the ap-
pliance operates in the mode selected before it shut
down.
CLEANING AND MAINTENANCE
Always remove the plug from the power socket before perform-
ing any cleaning or maintenance operations. For safety reasons,
never wash the dehumidier using a water jet.
Cleaning the cabinet
• Clean the appliance using a damp cloth then dry with a dry
cloth.
• Never use petrol, alcohol or solvents to clean the appliance.
• Never spray the appliance with insecticides or similar. These
could cause the plastic parts to warp.
Cleaning the dust air lter or silver-ion air lter
(on certain models only)
If the lter is dirty, air circulation is compromised and the ef-
ciency of dehumidifying is decreased. It is therefore good
practice to clean the lter at regular intervals. The frequency
depends on the environment and the duration of operation.
If the unit is used constantly or systematically, you are recom-
mended to clean the lter once a week.
• To remove the air lter, remove the grill and extract the lter
by pulling it (see Fig. 5).
• Use a vacuum cleaner to remove dust accumulations from
the lter. If the lter is very dirty, rinse well with lukewarm
water. The temperature of the water should not exceed 40˚C.
After washing the lter, allow it to dry completely before re-
inserting it.
If present, the silver-ion air lter, besides retaining powder
particles, has also an ecient antibacterial action. In addi-
tion, it greatly reduces irritants such as pollen and spores.
The lter is treated with small particles of silver (on the scale
of millionths of a millimetre) which are able to block the
multiplication of and destroy any bacteria or spores coming
into contact with them.
Anti-allergen lter (on certain models only)
Some models are equipped with an anti-allergen lter that can
notably reduce the concentration of allergens transported by air
in a quick and ecient way.
To apply the lter, remove it from the packaging and insert it
into its place in the grill at the back of the appliance, as shown
in Figure 6.
It is recommended to replace the lter every 2 years.
If the appliance is not used for long periods
• After unplugging the appliance from the power socket,
empty the tank.
• Clean and reposition the lter.
• Cover the appliance with a plastic bag to protect it from dust.
DISPOSAL
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
TECHNICAL SPECIFICATIONS
Power supply voltage See rating plate
Absorbed power “
Frost protection device Yes
Fan speeds 1
Air lter Yes
Anti-allergen lter (only on certain models) Yes
Tank capacity 2.1 litres
Operation limits:
temperature 2°C-30°C
relative humidity 30-90%