Instruction Manual

17
en
IF SOMETHING DOES NOT WORK
Check the following before calling the authorised Technical Service Centre operating in your area.
PROBLEMS CAUSES SOLUTION
The appliance is operating in dehumi-
difying mode but the humidity does
not decrease.
The lter is clogged.
Eitherthetemperatureorthehumidi-
ty in the room is too low.
The room is too large for the dehu-
midifying power of the appliance, or
there are too many sources of humidi-
ty (boiling pots, etc.).
The set humidity value is too high.
Clean the lter.
In certain conditions it is normal for
the appliance not to dehumidify.
Check the operating limits of the
appliance in the “Technical Speci-
cations” chapter. In certain cases it is
advisable to heat the room you wish
to dehumidify.
Decrease the set humidity value.
The appliance does not operate for ap-
proximately3minutesafterstartup.
The safety device has correctly made
the appliance trip.
Waitfor3minutestopass.
appears on the display
appears on the display
appears on the display
The tank is missing.
The tank is full.
The tank is positioned incorrectly.
The room temperature is very low.
Oneoftheprobesisfaultyorthehu-
midity in the room is too low or too
high to be detected correctly.
Put the tank back in place.
Emptythetank.
Position the tank correctly.
Increase, if possible, the room tempe-
rature.
See if the appliance starts working
again when moved into another
room with a level of humidity within
the operating limits indicated in the
“Technical Specications” section.
If the problem persists, call the Service
Centre.
Troubleshooting